Search:

Connect the black wire with the solid black, connect white wire with the greyish black and ground wire to the phillipps screw at the very top of the baseboard in your first photo.

It won't...

The qouted clause refers to 2 wet venting fixtures venting 1 fixture, in this case the toilet. The tub needs to be seperately vented and the lav becomes the wet venting fixture for the toilet.(as the...

The only thing that I find questionable is the section in the green circle. The 2 fixtures are not both draining in the same vertical continuous waste and vent.

That's the way I interpret the...

Are you sure it is a "positemp?" Correct me if I'm wrong, The only valve that I know that has the 2 "screws" on iether side (shut off valves/stops), is the moentrol.

If it is a moentrol, you...

These sinks are designed to sit in the hole with a bead of silicone chaulking holding it in place. Assemble your faucet and drain assembly first and then run a bead of silicone around your opening....

If your downspout is disconnected from the drain. Have the downspout diverted to your lawn and cap the exterior as well as what ever you need to connect inside. The inspector may still want you to...

The pipe that you see going to the "weeping tile" is probably a downspout drain. In the old days, they used to connect the eaves trough drains to the floor drain in the basement. If in fact you are...

The old clay may be coming from an old downspout drain. It depends on where it is coming from and where it ends up going.

The wet vent should be closest to the toliet. The shower/bath drains...

I'm going to put my money on rust build up in the galvanized lines, rather than the valve

Plumbing supplier will have all the test caps, plugs, balloons , except the billiard ball.

I beleive there is a Westburne plumbing supply close to you in New Market. 110 Harry Walker N....

Any "weight thing" that I have ever installed usually came where you could open it or split it in half and put it on after the hose is connected.Either clipped together or 2 scews to fasten the 2...

Its not really a good idea, as well as against code, to reduce the 2" to 1 1/2" down stream of the P-trap, especially on the horizontal run. It will be your primary spot for any future blockages.

...

Replace the hot water washer on the tap and the trickle will stop. While your at it , replace the cold water washer too.

95% of Canadians rarely use mechanical trap primers because they are prone...

I 'm not really clear what you are asking.

But, s-trap are not allowed anywhere in north America....... except maybe Mexico (maybe you mean p-trap) Let us know if you have a laundry sink in your...

It is allowable to go through a wall, but you need to exit at 45 degrees and extend to above the roof and any change of vertical direction must be 45 degrees. There should be no horizontal runs...

Just make sure that the pipe you run does not exceed 20Ft from the p-trap to the main stack, otherwise you will have to install cleanouts at 20ft intervals

Nothing wrong with them. I actually prefer them

Are you planning on making the waste water dizzy before it goes to the main stack?? Why would you want to add extra changes in direction for your waste water? Better chances for blockages to happen
...

What you have to do is raise the vent as high as you can above the horizontal plane of the drain and go to the nearest wall possible and come up at your 6" above your fixture. Code in Ontario...

You can try heating up the fitting only and then try turning it, or you can try smaking the fitting at the hub with a 2 hammers. I hammer stays stationary behind the fitting and the other hammer to...

Precisely. You may find a pin hole under the antisiphone cap. (its supposed to be there)

It has everything to do with the antisiphon. The piece ahead of the handle is interconnected to the spring load end of the stem.

pull it apart again and see if any sediment or particles are...

There are many different options with different waste and overflows http://www.oateyscs.com/bath_waste/bw_pdf/BathWaste_brochure.pdf

Absolutely nothing is impossible, its only a question of
(1)...

I have never heard of a frost free hose tap that uses the stem to deliver water. As far as what you described, the spring loaded piece on the end acts as an anti-siphoning device. The entire barrel...

How much damage do you think you are going to create if the hole is 2 1/8"? An extra 3/8" over the entire hole to make your life alot easier.