(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: hmmdinger; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    10
    Views
    2,982

    In my system, I have two dielectric unions at the...

    In my system, I have two dielectric unions at the end of all my new copper piping, one for the hot pipe, one for cold, where the new pipe transitions to old galvanized. I thought that would be a good...
  2. Replies
    10
    Views
    2,982

    Pressure testing copper supply lines?

    I recently installed a lot of copper piping and "tested" everything by just turning the water on. I had two leaks, one of which was due to a bad sweating job. With the pipes now wet, I had to cut out...
  3. Replies
    3
    Views
    2,619

    I completely empathize with your troubles,...

    I completely empathize with your troubles, DVDiva. That's the EXACT situation I was in a couple of weeks ago. Rubber adapter would fit on the pipe fine, and would fit into the hub fine, but try and...
  4. Replies
    7
    Views
    1,684

    When I recently tried to find local or even state...

    When I recently tried to find local or even state plumbing code, I was surprised and disappointed to find no online provider of the information. I would think the primary reason code exists is for...
  5. Replies
    16
    Views
    6,335

    Thanks for the diagram. I am only plumbing one...

    Thanks for the diagram. I am only plumbing one floor, but I see how everything is working. My main problem is still that my plumbing wall sits right on three joists. I did have to build an alcove to...
  6. Well, illegal in Mass. is enough to convince me...

    Well, illegal in Mass. is enough to convince me to shy away.

    Looking at it some more, I suppose it wouldn't be hard for waste coming down the larger elbow to end up getting into the inlet. That...
  7. PVC Fitting - Using Elbow w/inlet w/toilet drain

    Hello,

    I'm still planning out my DWV system, and came across two similar fittings that look very convenient for what I want to do.

    They are both elbows with side inlets. Is it acceptable to use...
  8. Replies
    16
    Views
    6,335

    My problem with venting the toilet immediately is...

    My problem with venting the toilet immediately is that my fixtures are against a wall running right on top of a tripled-up 2x8 joist...can't go through it. I was actually going to bring my vent up...
  9. Replies
    16
    Views
    6,335

    First off, I REALLY appreciate the advice so far....

    First off, I REALLY appreciate the advice so far. It's incredibly reassuring to have this resource available.

    I have edited my diagram, based on what I THINK everybody was talking about. Kind of...
  10. Replies
    16
    Views
    6,335

    How's this for a DWV setup?

    Hello all, great site here.

    I am replacing the plumbing for a bathroom on the main level of my house. Before I actually begin the DWV piping, I was hoping to find out if it is as simple as I have...
Results 1 to 10 of 10