(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: rayleeis; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    7
    Views
    1,266

    Response

    There is no clean out. My snake line is 1/4" thick.

    I also tried this chemical that melts grease and hair by creating heat...let it sit for about two hours...and pour boiling water in sink...the...
  2. Replies
    7
    Views
    1,266

    I think so , I have 15 ft. snake...and I had my...

    I think so , I have 15 ft. snake...and I had my father listen to hear if the snake is reaching where I think teh clogg is...everything after point is not clogged...

    I bought this stuff, and it...
  3. Replies
    7
    Views
    1,266

    How To Remove a CLog

    Hello,

    I think I may have a clog that cannot be reached with a snake or is too hard for a snake to drill through. I could go up to the roof and put a snake down the vent and be sure that I am...
  4. Replies
    3
    Views
    3,850

    Because of the drain for the sink...the drain for...

    Because of the drain for the sink...the drain for the sink itself is like 5 inches deep...and it is threaded...so i had to buy a female threated adaptor, then attached a special pipe with a...
  5. Replies
    3
    Views
    3,850

    SINK CLOGGED! P-trap too low for waste stub.

    Hello,

    Please take a look at the picture I've attached.

    My Sink does not drain.

    My P-Trap is lower than the waste line and I cannot connect to the stub out.

    I've put two 90 degree angle...
Results 1 to 5 of 5