(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: lextech; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    4
    Views
    2,142

    There is a table in the furnace installation...

    There is a table in the furnace installation manual that will tell you the maximum length allowed for your vent. It is based on the pipe size 2.5, 3, 4 etc. plus the number of elbows in the vent...
  2. A) Pressure loss in the duct due to turbulence,...

    A) Pressure loss in the duct due to turbulence, balancing assures that the CFM requirement of a space is met...the air is balanced for the space neither too much nor too little only that which is...
  3. Replies
    2
    Views
    1,247

    Try this site:...

    Try this site: http://www.batticdoor.com/atticstairinsulator.html I think they have what you're looking for.
  4. Replies
    4
    Views
    2,898

    I believe Centurion is made by York. So you...

    I believe Centurion is made by York. So you should be able to get another manual from a York distributor.

    The pressure switch is located in the cabinet usually near the induced draft motor. You...
  5. Replies
    7
    Views
    3,231

    Oops you're right I mis-stated about the hartford...

    Oops you're right I mis-stated about the hartford loop, you are correct. The old systems without a hartford loop usually had a check valve, which may have been upgraded to a condesate or feed pump....
  6. Replies
    7
    Views
    3,231

    A hartford loop is used to get condesate back...

    A hartford loop is used to get condesate back into the boiler. A condensate or boiler feed pump are usually subsituted for a hartford loop. Anyway if you can't see the water level in your gauge glass...
  7. Replies
    7
    Views
    11,990

    Go down to the HVAC supply house and get some...

    Go down to the HVAC supply house and get some duct sealer (a.k.a. pooky) and a couple of paint brushes. Then paint the duct sealer on every joint, including start collars, in the duct work, let it...
Results 1 to 7 of 7