Search:

About a 1 1/2 years ago I installed a Nuvo water softener. I seems to be working pretty good. My home hard water test kit showed a hardness less than 2, but mineral deposits were still forming on the...

The Toto Drake is a mediocre toilet???? The flange is an ordinary Nibco or Mueller ABS flange. The seal is a Fernco wax free. All stuff one could expect to work together nicely, but doesn't.

Well, it's been a few months and the bathrooms are done, along with all the house, and we are moved in! My experience with the toilet installations was pretty much dead on with the response above. I...

I find several comments in this forum where the authors say a toilet flange should be on top of the finished floor. There are also a couple of posts where in that case the poster had problems with...

The plumbing code for the State of Idaho was changed last spring to require the installation of a water softener loop (softener not mandated), plus hard cold water, soft cold water, and soft hot...

Anyone have experience with the Oetiker ratchet crimp ring tool and the Oetiker stainless steel crimp rings? As a DIY building my own house it looks like a good way to go, especially since it's one...

I'm planning on putting a PEX manifold for bathroom & utility room water supply in the wall of the utility room. The manifold will be 3/4" main line and 1/2" branch lines. The wall is common with a...

I'm resurrecting this thread because I have the same question today. Anyone have any first hand knowledge about the Kohler Leighton?

I think the tool and clamps come from Watts, but they are branded by Zurn and whoever else. Look to me like a pretty good way. Advantages of crimp with an easy to install format using stainless steel...

I can't find a clear cut answer for this, and the plumbing inspector won't be available until Tuesday.

If I put a cleanout in the drain line for a lavatory in the vertical pipe just above the san...