Search:

Yes, I was very pleased. The labor was $150. for 2 men. No supplies. Shut pump power, drain tank, unscrew two pipes and drag the old one away. Reconnect new, check air and start filling while...

Thanks to all replies. Had Associated Drilling out of Manchaca, Texas come out. The 5 year old Challenger had a rusted out welded "malleable" elbow leaking. I had them install another challenger...

I just noticed a leak under my pressure tank in the garage. This tank was installed July 2006. The previous one (same model) was installed in 2002 and failed the same way. The leaking water is...

Needle permanently stuck after a freeze.

My gauge has frozen again. Can anyone suggest a gauge that will not freeze? It is exposed.

I am having what seems to be a well pressure problem. It is ONLY evident when the lawn sprinklers are on, so far. When any zone is watering, the pressure starts out good, then gradually drops to a...

OK, today I got my TDS tester in the mail. It appears my RO 15 month membrane is not even working a little. TDS is 175 from BOTH kitchen faucet and RO faucet. TDS is 120 from refrigerator. AND...

I just measured my hardness with the Hach kit. 80 drops before it turns blue. So 80. . I am using 40 pounds of Morton System Saver per 8 days. Two people in the house. The undersink RO system...

A neighbor is selling RO systems. He offered to measure my mineral content. I currently have a RaynePure under sink system that purifies Rayne conditioned well water. The RO water measured 240PPM....

Folks, it is getting dry in South Texas (West Travis County) I am on a well in the Trinity. Wells around me are going dry. I have decided to at least install a pump shut off switch to save my pump...

Thanks. Just to be sure...removing the leak guard will revert it to a 400a?

Gentlemen, today I installed a new Fluidmaster 402LG fill valve with the leak guard. I am unable to get the leakguard to work properly. When I simulate a flapper leak, the float does not stay up. ...

Thanks Rancher

Bear with me:

Do I just drain the tank by powering down pump, then opening a faucet??

Sooo, what is the correct, step-by-step procedure to fill and/or adjust air pressure in a bladder pressure tank.

I have a challenger 85 gal. I would like to set my switch at 40/70. Assuming the...

Gentlemen, just finished replacing my pressure gauge. It was zero'd on 40 psi. Now I THINK it is back to normal. Was a little concerned about my operating pressures though. 50/80 psi. Had a new...