(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: dmaceld; Keyword(s):

Search: Search took 0.15 seconds.

  1. Replies
    3
    Views
    339

    It's been over a year and no responses so thought...

    It's been over a year and no responses so thought I would see if I can revive this question.
  2. Replies
    3
    Views
    339

    Cleaning off mineral deposits

    About a 1 1/2 years ago I installed a Nuvo water softener. I seems to be working pretty good. My home hard water test kit showed a hardness less than 2, but mineral deposits were still forming on the...
  3. Replies
    36
    Views
    38,573

    The Toto Drake is a mediocre toilet???? The...

    The Toto Drake is a mediocre toilet???? The flange is an ordinary Nibco or Mueller ABS flange. The seal is a Fernco wax free. All stuff one could expect to work together nicely, but doesn't.
  4. Replies
    36
    Views
    38,573

    Well, it's been a few months and the bathrooms...

    Well, it's been a few months and the bathrooms are done, along with all the house, and we are moved in! My experience with the toilet installations was pretty much dead on with the response above. I...
  5. Replies
    36
    Views
    38,573

    Toilet flange above or level with floor

    I find several comments in this forum where the authors say a toilet flange should be on top of the finished floor. There are also a couple of posts where in that case the poster had problems with...
  6. Replies
    7
    Views
    1,908

    The plumbing code for the State of Idaho was...

    The plumbing code for the State of Idaho was changed last spring to require the installation of a water softener loop (softener not mandated), plus hard cold water, soft cold water, and soft hot...
  7. Replies
    5
    Views
    3,846

    Oetiker crimp tool

    Anyone have experience with the Oetiker ratchet crimp ring tool and the Oetiker stainless steel crimp rings? As a DIY building my own house it looks like a good way to go, especially since it's one...
  8. Replies
    2
    Views
    1,028

    PEX manifold noise

    I'm planning on putting a PEX manifold for bathroom & utility room water supply in the wall of the utility room. The manifold will be 3/4" main line and 1/2" branch lines. The wall is common with a...
  9. Replies
    1
    Views
    1,341

    I'm resurrecting this thread because I have the...

    I'm resurrecting this thread because I have the same question today. Anyone have any first hand knowledge about the Kohler Leighton?
  10. Replies
    5
    Views
    9,451

    What about Quick Clamp?

    I think the tool and clamps come from Watts, but they are branded by Zurn and whoever else. Look to me like a pretty good way. Advantages of crimp with an easy to install format using stainless steel...
  11. Replies
    1
    Views
    543

    Cleanout for sink drain

    I can't find a clear cut answer for this, and the plumbing inspector won't be available until Tuesday.

    If I put a cleanout in the drain line for a lavatory in the vertical pipe just above the san...
Results 1 to 11 of 11