Search:

I'm looking at using the Caroma Caravelle 270 or the Tasman 270 to replace a toilet that needs a 10" rough in. Another option is the American Standard Cadet 3459 (10” rough in), but the Caroma does...

Need more help! I'm installing a new delta tub/shower valve, tub spout and shower head.
Questions:
1. How high should the showerhead be? It will be about 72" from the bottom of the tub to the elbow...

I bought the shut-off valves and stainless steel braided hose to connect the ½” galvanized plumbing in the wall to the bathroom sink hot/cold and the toilet. The ball valves I bought are ½” female...

mark and jimbo,

Thanks for the help. One more question:
Will the male IPS threads (straight) on the Delta work with the galvanized couplers (NPT taper I presume)? I plan to use teflon tape for...

All,

I need some advice for installing a new tub/shower valve. The first two photos show the existing arrangement, and the last photo shows the new valve. I want to use galvanized pipe and...

I’ve been working on preparing a small bathroom for a tile install. The subfloor is ¾” plywood over I-beam type joists. There is a finished basement below. The joists are 16” on center and assuming...

I started thinking I may want to replace the floor some day (this is my 1st tile project) so...would it be more prudent to tile up to the vanity, and if my tile job goes south I can take it out w/o...

The house was built in 1979. The pipe and flange look to be black PVC and the part that is screwed down is painted-pressed-sheet metal. The particle board around the base is soft (ruined) due to some...

I’m preparing a bathroom for tile installation and I’ve been removing a 3/8 layer of glued down particle board that had vinyl floor attached to it. The particle board is attached to ¾” plywood. It...

I'm in the same boat, and want to make sure I understand your suggestion. You are saying it is easier to go ahead and tile the floor and run the tile into the area where the vanity cabinet will sit...

I’m working on a bathroom remodel. The last couple evenings I’ve been chiseling/scraping a 3/8” layer of glued down particle board off of the ¾” plywood sub-floor. I found a pneumatic automotive...