Search:

See previous posts;


http://www.terrylove.com/forums/showthread.php?18206-Rear-discharge-toilet-seal-options

Always search for answers first.

Another item is water pressure. ALL MY lines that come off of the house lines have one.

http://www.dripirrigation.ca/wizard2Over.asp?name=Kevin&category=flowers&Submit=Go+to+the+next+step

Here is a manual that I used to do the design when I lived in New York State. My design passed.
...

Thanks for the recommendation. I will give the Tilex a try.

Thanks for the advice.

Replaced the 3 Red Washers and works fine now that I got the minor leaks stopped.

We have 4 Toilets - all Mansfield 160's.

In ONLY ONE there is a Black Scum in places and some of this scum floats off when we flush.
Where it is stuck on parts, it is hard to remove.

This...

I have 3 toilets with extremely sticky Mansfield Flush Valves on 160 Toilets after 6 years.

I read somewhere that this is caused by suction and bad gaskets after use of chlorine in the tanks. (My...

I also have used my "Dremel" to cut the ring

Thenecessary length of a conventional septic drainfield trench as a function of the soil percolation rate and the anticipated daily wastewater flow from the building served. The field is a series...

You may want to read the attached guide and using the calculations and chart 9.12 to determine overall dynamic head. ...

Hey Ballvalve... LOL Jaaaaaaaaaaaaaaaaaaaaa :cool:

If you took all that out why not just saw off the nipple or drill a hole, or bang a hole to drain the Old HW Heater ?
:cool: I think you should rethink who you call names before you "Dance with...

Well I have had a Great one.....and I think these attributes means they are professional

1. Would tell you you "Don't Need to pump out" and gives an estimate when
2. Will do an Annual Inspection...

Metal pans are available off the shelf but not in your Hoem Box Store.

http://www.killarneymetals.com/machine_washer_drip_pan_ppsqo_vhv59100ytw_vhv147ytw_vhv4ytw_vhv59100ytw.aspx

If you go up...

Looks like HDPE "Poly 3-Wal" - or Similar manufacturer. Uses Std 4" fittings.

You can get a Brochure on it at
http://www.baughmantile.com/triplewall.htm

Sinks
Drain Pipe: About 16-20 inches above floor. We will consider the drain pipe to be a vertical centerline.
Supply Lines: Two holes. One hole is 4 inches to the right of centerline, another hole...

Take a look at Camping and RV Suppliers. They use some of this type and size.

example http://www.gowesty.com/ec_view_details.php?id=4059&category_id=362&category_parent_id=

I also got some odd...

Here is the address I have for them. Try Calling.

Davke Shower Drain
3170 W. Lakeside Dr.
Moses Lake, WA. 98837-2923
509-764-0550; fax: 509-764-9275

Look at these 2 : One is an older post.

http://www.terrylove.com/forums/showthread.php?7565-how-does-electric-sprinkler-valve-work

...

I have had external line fed Gas Grills for years. I prefer tru-flex line as it can be buried and is protected with polyproplene coating.

Check it out "Tru-Flex"

The GAS Quick disconnect is...

15265

They Do Exist - Try Local Plumbing Supply House or take a piece of pi[pe to machine shop and have it cut and Tapped on the Inside.

You could also use a Coupling and a small stub piece of...

JK60, not sure where yoiu live but.

Here in my area of North Carolina , all BFP and PRV are located outside , above ground 18" by code and are generally put into an isulated Box(Fake Rock) or...

Their concern should be if it was put in by a makeshift handyperson or in a very small holding tank that will cause Pump wearout.

I had a grinder system similar to "http://www.sammplat.wa.org/GrinderPumpFlyer.pdf when I lived in Western New York.

Mine went over a 500 foot run to the Sewer Manhole thru a dip in the woods with...

It would be simple just to box the pipes in with a simple 3" deep x 6" wide box. And then paint the same as the Garage.