Search:

I am rdemodeling my master bath. The orig. bath had a bedit next to where the new shower wall will be. I am getting rid of the bedit and want to use its water supply (h & c) as the source for my...

I am installing a thermostatic mixing valve in my shower. Instruction manual says to install water hammer arrestors. The shower that I am replacing had no such arrestors and there was no noise from...

Hi Patrick88

I agree, not much of a choice in this case.
Thanks for your advice.

Hi Partick88

Finally reduced the size of these pics. Hope you can make out what I am talking about.
One pic shows the 4" abs with "stiffener" on underside. At the near end is the rubber coupling...

Hi Frenchie

Installation manual calls for cold or hot water line, however hot water is preferable.

Patrick88

I tried to send jpg pics of drain. One w/rubber coupling attached, one w/cut-off collar of 90 and one showing drain, slab and new hole/trench where new p-trap and drain pipes will go....

I am relocating my bath tub. I need to move the drain (which is under concrete slab) approx. 2' at 90 deg. angle. The drain is 2" abs. My problem is that there isn't enough clean abs for new...

I am remodeling my master bath and have a few questions.
1)The new shower wall is within 1 foot of a 1/2" copper water supply (H & C thru concrete slab) that was used for the bidet but no longer...