Search:

Finally a working furnace!!! I replaced the control board which had a bad motor relay. It was burnt right behind the relay where it is soldered in. I ended up paying $49 for a new control board. A...

After replacing the pressure switch the furnace ignitor will glow and the burners will kick on. After about a minute the main blower motor fails to start and the unit shuts down. The next thing I...

Thanks Jim, I took apart the draft inducer, the exhaust pipe and cap and the hose. I then cleaned everything thoroughly and checked the hose for any cracks or splits. There were no obstructions in...

Thanks for the info Thatguy.

I will purchase some hose and try the test. If that is succesful and I need a pressure switch can you recomend a web site to purcahse one? The furnace is a Ducane...

OK, I have narrowed down my problem to the draft inducer motor or the pressure switch. Here is what I have tried:

When I apply suction to the pressure switch the ignitor will glow and the furnace...

On Sept 28th I posted the following: Ducane Furnace model # MPGA07583A. When I turn on the thermostat the exhaust fan turns on for about 25 seconds then the unit shuts down. The error code...

Thanks EH,
I will give it a try and post the results. Do you know of a good site where I can order the part from. Everything I have looked at here locally is super expensive! Thanks again!

Dean
...

Hello,

I have a Ducane Furnace model # MPGA07583A. When I turn on the thermostat the exhaust fan turns on for about 25 seconds then the unit shuts down. The error code blinks 3 times then...

Speedbump, thanks for the reply. It turned out to be a waterlogged tank. the well screen is also plugged. I am also going to treat the well screen with tabs and flush with water as you...

Bob thanks for the reply. I put in about 48' of 1 1/2" pipe. Can you suggest a good quality switch? Today I was planning on pulling the pvc pipe and replacing it along with the foot valve. I was...

Bob thanks for the advice. I will check the things you mentioned.

About 9 years ago my father and I sunk a sandpoint well. We went down about 50 feet using 2" galvanized pipe. I installed a well x trol pressure tank model wx302 and a 1 h.p. standard Fairbanks Morse...