(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: jdieter; Keyword(s):

Search: Search took 0.10 seconds.

  1. Thanks for the replies, I placed the trap...

    Thanks for the replies, I placed the trap directly under the drain with a vent T after that, so if I ever need to clean the trap it will be though the drain. The house was built in the early 70's and...
  2. Basement Bathroom Remodel with neo-angle shower pan

    I'm ok with code venting requirements, but couldn't find anything about burying the p-trap under the pan and under the newly poured concrete I had to bust out to do the rough-in. If I moved the trap...
  3. Thanks on the valve link. I'm concerned about...

    Thanks on the valve link. I'm concerned about hard plumbing between the pump inlet and the plastic reservoir tank stressing the bulkhead fitting from the pump starting torque. I'll mount the pump on...
  4. I'm not familiar with a scrubber valve so a quick...

    I'm not familiar with a scrubber valve so a quick search and I found them in irrigation applications. Would irrigation valve be ok for drinking water? it sounds like I need a direct acting valve...
  5. setting up a reservoir tank for low producing well

    Type of pump?
    Submersible__Gould______
    Two wire (no control)________
    Three wire (control box)_Gould Pump Protector_____
    Wire Size____#10_____ Wire Length__175'______
    or
    Jet Pump (above...
  6. Replies
    5
    Views
    1,929

    I did some digging and understand what a shorud...

    I did some digging and understand what a shorud is and does so sorry about commenting without knowing what I was talking about.

    As my well sets today the Pumptec stops the pump in about 15 minutes...
  7. Replies
    5
    Views
    1,929

    I wasn't clear regarding the cooling, the pump...

    I wasn't clear regarding the cooling, the pump I'm concerned about is the submersible so unless I'm missing something about a cooling shround, I mislead you. Also should the restriction but at the...
  8. Replies
    5
    Views
    1,929

    Storage tank setup

    Over the last 12 years my well output has dropped from 5gpm to 2gpm. Not enough for my water softener to cycle properly. I've had the original driller check the well and there wasn't much they could...
  9. Replies
    10
    Views
    1,194

    Thanks for all the help, going to ride out the...

    Thanks for all the help, going to ride out the winter and get all this resolved in the spring.
  10. Replies
    10
    Views
    1,194

    Thanks for the sand filter info, I suppose I...

    Thanks for the sand filter info, I suppose I monitor the pressure drop across the filter to determine backflush. Is there anything special about the sand?
  11. Replies
    10
    Views
    1,194

    Can you give me a link, quote + shipping on the...

    Can you give me a link, quote + shipping on the sand filter, not sure at this point if I need one (see what the driller comes up with) and if I would want auto or manual, my zip is 46923. If it's...
  12. Replies
    10
    Views
    1,194

    ok, the well is 12 years old, so it's acceptable...

    ok, the well is 12 years old, so it's acceptable to buy a new pump every 10/12 years. The area I'm in is water-challanged, my neighbor had to drive a new well and the other neighbor had 3 wells...
  13. Replies
    10
    Views
    1,194

    Ouch I was afraid of that. I've got a gauge...

    Ouch I was afraid of that. I've got a gauge downstream of the cartridge filter. I'll do a manual regen on the softener and watch the pressure.
    Is there any help for the well if I have the driller...
  14. Replies
    10
    Views
    1,194

    Sand, low pressure and H2O softener

    I have a submersible down around 60ft and recently started getting an excessive amount of sand. My inline filter after the pressure tank was nearly full of sand. Here's some history on my water...
Results 1 to 14 of 14