(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: hidden 1; Keyword(s):

Search: Search took 0.13 seconds.

  1. Replies
    4
    Views
    939

    I had a feeling it could be ballast since its got...

    I had a feeling it could be ballast since its got a louder of a buzz after the reset of fuse .
    I may just replace light .I dont think the sodium bulb can factor in on the louder buzzing than usual.
  2. Replies
    4
    Views
    939

    photocell light

    i have a outside light that uses a large sodium bulb with a photocell.comes on at dark off at dusk.i changed the photocell a year ago w no problems ,but lately it has been off and breaker tripped as...
  3. Thread: toilet chugs

    by hidden 1
    Replies
    1
    Views
    860

    toilet chugs

    I have an older home and i think the toilet air pipe may have junk/maybe bird nest? in it .Everytime it flushes it makes that "chug chug" noise at end of flush and i hear it a bit from tub drain...
  4. Replies
    13
    Views
    4,414

    Hi ,I just installed a tank also and made a shelf...

    Hi ,I just installed a tank also and made a shelf off the wall for supporting the tank, a good heavy duty "L" bracket/board,into stud, works great for shelf .
    I also set the air pressure about 3 lbs...
  5. Replies
    32
    Views
    26,524

    are these the Lowes whirlpool water heaters with...

    are these the Lowes whirlpool water heaters with that smart box computer on em.?.i had to change the control box out on one once.. ill look at the screens more now for sure!
  6. Replies
    18
    Views
    4,065

    if it was done in Ill i bet it would not be...

    if it was done in Ill i bet it would not be covered(flood insurance ,codes,etc) unless it was installed as state required....if i have to change mine ill turn off the valve before tank tee, let out ...
  7. happy its holding thru for you..I installed prv...

    happy its holding thru for you..I installed prv and expansion tank and its doing fine .i just need to readjust the air pressure in tank ..i think its 5psi under pressure coming to water heater if im...
  8. Replies
    5
    Views
    4,174

    Hi ,i didnt have a drain in floor either and had...

    Hi ,i didnt have a drain in floor either and had the choice of a adjustable pressure relief valve before the heater on cold line(temp adjusted just below the one on water heater)- then emptied ...
  9. Replies
    6
    Views
    1,345

    And worst case scenerio i can tap into the cold ...

    And worst case scenerio i can tap into the cold line coming up to water heater (regulated already 55)--connect seperately to that cold valve , and cap off old one that was linked before...
  10. Replies
    6
    Views
    1,345

    thanks for the info. so i should set tank at 52...

    thanks for the info.
    so i should set tank at 52 or53 if the regulator is set at 55?...

    will the water hammer arrester cushon the spike during off/on cycles and when not in use also, with washer ?...
  11. Replies
    6
    Views
    1,345

    pressure reducing valve/relief

    Hi i have installed a pressure reducing valve on the main inline .there is a backflow valve at meter.there is also a expansion tank on cold at water heater..is 55 on prv and 45 -tank about where it...
Results 1 to 11 of 11