(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: cwhyu2; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.17 seconds.

  1. I would like to see a picture and that maybey...

    I would like to see a picture and that maybey help you,
  2. Replies
    3
    Views
    205

    I use j hooks where there joists for a long...

    I use j hooks where there joists for a long horisantal run.
  3. The silver looking nut holding the grey part in.

    The silver looking nut holding the grey part in.
  4. Replies
    5
    Views
    217

    You could also buy a new seat.Easy to install and...

    You could also buy a new seat.Easy to install and you can get them at any hardware
    store.
  5. Replies
    4
    Views
    272

    The drain in the wall needs to (snaked) out...

    The drain in the wall needs to (snaked) out either from a clean out in the basement or from under the sink at the wall.
  6. Replies
    8
    Views
    395

    If was not a perfect rough I would set the valves...

    If was not a perfect rough I would set the valves at floor level and use crhome supply tubes,I have used 38 inch supply tubes and set the valves almost at floor level.
    And the tubes I used are...
  7. Replies
    8
    Views
    395

    Is this a floor supplied sink?

    Is this a floor supplied sink?
  8. Replies
    8
    Views
    440

    Thanks for your advice going with copper and will...

    Thanks for your advice going with copper and will open wall,no solder joints on risers.
    Will not use shark bite fittings,
  9. Replies
    8
    Views
    440

    PEX to copper, PEX to galvanized

    I would like to know more as I have to pull Pex or type L soft copper to a 2nd fl kitchen sink,one hundred year old house,without opening walls.
    Have to cut out old galvlnzed in basement, and want...
  10. Replies
    15
    Views
    627

    That picture with the hose faucet sticking out...

    That picture with the hose faucet sticking out looks like it was taken before the brick veneer was installed.
    Looks you may be able to twist it out.
  11. Replies
    2
    Views
    146

    Okay that was cool had this happen to many times.

    Okay that was cool had this happen to many times.
  12. Replies
    16
    Views
    546

    That was my thought too.

    That was my thought too.
  13. Replies
    18
    Views
    784

    Thank you, Nicholas. for that post, did faucet...

    Thank you, Nicholas. for that post, did faucet repairs for many years and could repair a lot of the older faucets easier and have them last a long time.
  14. maybe unions attacthed to the water lines in back...

    maybe unions attacthed to the water lines in back of the faucet.
  15. Thread: Wet Bar Outlets

    by cwhyu2
    Replies
    44
    Views
    1,743

    That was interesting.

    That was interesting.
  16. Thread: Wet Bar Outlets

    by cwhyu2
    Replies
    44
    Views
    1,743

    I disagree, why would you need a Fridge GFCI...

    I disagree, why would you need a Fridge GFCI protected never would do that and AFCI in a kitchen every time the motor on any appliance is going to spark and that would trip the AFCI.
  17. Thread: Wet Bar Outlets

    by cwhyu2
    Replies
    44
    Views
    1,743

    Just read 2014 NEC codes for AFCI and I stand...

    Just read 2014 NEC codes for AFCI and I stand corrected!
  18. Thread: Wet Bar Outlets

    by cwhyu2
    Replies
    44
    Views
    1,743

    From what I have read the kitchen and bath do not...

    From what I have read the kitchen and bath do not have to be on AFCI.
  19. Thread: Wet Bar Outlets

    by cwhyu2
    Replies
    44
    Views
    1,743

    If I have a dedicated 20 amp circuit to a...

    If I have a dedicated 20 amp circuit to a refrigerator it does not have to be AFCI protected?
  20. Can you post a picture?

    Can you post a picture?
  21. Your best bet is to remove the old nipple and...

    Your best bet is to remove the old nipple and replace with a brass nipple that fits your spout.
  22. Replies
    18
    Views
    784

    I used to carry brass,monel,and ss retainers in...

    I used to carry brass,monel,and ss retainers in my faucet repair kit.from ooo to 1/4 L .
  23. Thread: everyone

    by cwhyu2
    Replies
    7
    Views
    597

    Merry Christmas!

    Merry Christmas!
  24. Replies
    17
    Views
    1,039

    Split buss panel?

    Split buss panel?
  25. Replies
    18
    Views
    1,235

    Is something like what you are going to connect...

    Is something like what you are going to connect your three part sink to?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4