(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: 1890farmhouse; Keyword(s):

Search: Search took 0.16 seconds.

  1. Replies
    2
    Views
    1,287

    Thanks for the info. They are threaded...

    Thanks for the info. They are threaded connections. I will probably add additional tees to the iron pipe to accomodate the upstairs radiator so it will have its own piping.
  2. Replies
    2
    Views
    1,287

    Flat Panel Radiators

    I plan to replace two cast iron radiators with Runtal flat panel radiators; one on the first floor and one directly above on the second floor. The existing hot water system has black iron pipe. ...
  3. Replies
    8
    Views
    1,256

    First floor. Looks like I will have to try to...

    First floor. Looks like I will have to try to create a path to the attic. The 4" diameter is hard to hide within standard 3 1/2" wide framing for walls. I read about someone who ran false exposed...
  4. Replies
    1
    Views
    512

    New Connection to Sewer

    I need to connect a new 4" PVC waste line for a new bathroom to an existing 4" PVC main line that runs to the street. Both lines will be subslab in the basement (currently dirt floor) and intersect...
  5. Replies
    8
    Views
    1,256

    There is even more in the way through the...

    There is even more in the way through the basement. As statjunk said, it is centrally located so there's no direct or easy route to the outside.
  6. Replies
    8
    Views
    1,256

    Fan for New 1/2 Bathroom

    I am building a new 1st floor 1/2 bathroom near the center of my 2-story colonial house with a full basement. It will be 3' x 7', toilet on one end and pedestal sink at other end. I want to install...
  7. Replies
    4
    Views
    766

    The new full bathroom is on the opposite side of...

    The new full bathroom is on the opposite side of the house from existing 4" line on 2nd floor. The new 3" toilet drain will run from 2nd floor to basement ceiling, then 90 degree bend (w/cleanout)...
  8. Replies
    4
    Views
    766

    Anyone have any suggestions on this one? I would...

    Anyone have any suggestions on this one? I would appreciate your help.
  9. I drilled the cover of one out with a series of...

    I drilled the cover of one out with a series of 1/2" drilled holes. The metal cover was soft and easy to drill through. Once I had drilled enough holes I was able to pry it out without damaging the...
  10. Replies
    4
    Views
    766

    New Sewer Connection

    I need to tie into my existing 4" PVC sewer pipe, which runs under the dirt floor in my basement, for a new bathroom. The new line will enter at 90 degrees and also needs to be beneath the dirt...
  11. Replies
    2
    Views
    1,943

    The house is circa 1890, so the system was...

    The house is circa 1890, so the system was installed later, but is still very old. I have moved some radiators successfully within the same room, but was working off an existing Tee. I understand...
  12. Replies
    2
    Views
    1,943

    Cast Iron Radiator for New Room

    My house has a two-pipe, single-loop hydronic heating system with cast iron radiators. I want to add a small cast iron radiator to a new 2nd floor bathroom. The pipes are all black metal with cast...
Results 1 to 12 of 12