(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Plumber2000; Keyword(s):

Page 1 of 8 1 2 3 4

Search: Search took 0.16 seconds.

  1. Replies
    3
    Views
    1,443

    It does not matter what slot you use, as long as...

    It does not matter what slot you use, as long as you use extra nut and waher to tighten it up on to the flange, ABS flanges with metal rings, the ones that are painted rings, there trouble, when the...
  2. Replies
    9
    Views
    4,708

    American Standard makes a 10" rough

    American Standard makes a 10" rough
  3. Replies
    1
    Views
    1,936

    Are you talking about the integral stops located...

    Are you talking about the integral stops located on the body of the valve left and right of the center of the valve?
  4. Replies
    1
    Views
    1,962

    Mike post a picture.

    Mike post a picture.
  5. Replies
    2
    Views
    1,805

    Replace the entire valve, body and all, not just...

    Replace the entire valve, body and all, not just the innards.
  6. Replies
    5
    Views
    2,030

    Remove the flow restricter out of the shower...

    Remove the flow restricter out of the shower head, you can see it when looking into it, pick will help remove it.
  7. Replies
    9
    Views
    5,152

    How about going with a marble surround, they are...

    How about going with a marble surround, they are cut to what ever measurements are needed.
  8. Depending on what code you use, here to run the...

    Depending on what code you use, here to run the vent below the window sill where it will not be 6" above the flood level rim of said sink, we can use long radius 90 turn/s for the vent if below the...
  9. Replies
    2
    Views
    1,923

    End of the tailpiece, then route the drain to the...

    End of the tailpiece, then route the drain to the trap location.
  10. Replies
    5
    Views
    2,256

    Steve, Usually the fitting will be ok, go for...

    Steve,

    Usually the fitting will be ok, go for it.
  11. Replies
    3
    Views
    1,747

    If you like hot water to the toilet, hot water to...

    If you like hot water to the toilet, hot water to ice maker if you have one, and all faucet reversed when turned on, then no it will not matter,
  12. Replies
    1
    Views
    1,684

    You have a frostproof hose bib there, if where it...

    You have a frostproof hose bib there, if where it screws into the wall fitting is secure then you should be able to unscrew it and install a new one, turn off the water first.
  13. Replies
    1
    Views
    1,745

    Turn down the water flow at shut off, if water is...

    Turn down the water flow at shut off, if water is entering tank too rapid, this can cause flapper to not seat back down.
  14. Replies
    8
    Views
    2,312

    There are poly by pex adapters one can use, crimp...

    There are poly by pex adapters one can use, crimp on the adapters and then finish it off with pex pipe and fittings.
  15. Thread: Stub outs

    by Plumber2000
    Replies
    1
    Views
    1,565

    Rough the water stubs outs just above the drain...

    Rough the water stubs outs just above the drain stub out.

    Kitchen drain stub should be 17" off floor and lav stub out should be 20" off floor.
  16. Replies
    13
    Views
    5,288

    Jimbo your probably right, in a CED class it was...

    Jimbo your probably right, in a CED class it was brought up and the instructor, long time inspector in this are says it can be used, maybe it's a different type of stuff then what is asked about on...
  17. Replies
    12
    Views
    3,688

    Terry, I don't think there code approved....

    Terry,

    I don't think there code approved. Correct if I'm wrong.
  18. Replies
    12
    Views
    3,688

    Do wax only, you will sleep better at night if...

    Do wax only, you will sleep better at night if you do.
  19. Replies
    3
    Views
    2,763

    Apply silicon in between the flange extensions,...

    Apply silicon in between the flange extensions, screw them down and set the toilet.
  20. Replies
    1
    Views
    1,581

    Find a new spot to install a clean out, dig it...

    Find a new spot to install a clean out, dig it out and install one, if you have knowledge of fitting needed then should not be the hard to install one.
  21. Replies
    2
    Views
    1,351

    Yes use silicone.

    Yes use silicone.
  22. Always leave the back edge uncaulked, reason is,...

    Always leave the back edge uncaulked, reason is, if the wax ever failed you will see a problem before it's to late, besides, code says there will be a smooth transition between different surfaces, be...
  23. Apply some a few coats of pvc glue around the...

    Apply some a few coats of pvc glue around the joint, let dry real good, this will probably solve the leak.
  24. Replies
    4
    Views
    2,314

    Check the blow hole and flush ring, these can...

    Check the blow hole and flush ring, these can cause this if there clogged with calcium build up in them.
  25. Replies
    1
    Views
    1,276

    New home being built, adjust the walls to make up...

    New home being built, adjust the walls to make up space needed.
Results 1 to 25 of 196
Page 1 of 8 1 2 3 4