(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: The Marble Guy; Keyword(s):

Search: Search took 0.15 seconds.

  1. Replies
    3
    Views
    2,383

    I`m sorry for the misinformation on the website...

    I`m sorry for the misinformation on the website address it is

    http://www.design-imaging.com

    I think the image is 8 mils. BTW marble and gelcoated products should never be scrubbed with ANY...
  2. Replies
    4
    Views
    1,862

    You can cut it with a fine tooth or metal hold...

    You can cut it with a fine tooth or metal hold saw or jigsaw.(14tpi) I use a 4-1/2 inch hole saw on cultured marble for the valve. It works much in the same way. I have installed both and enjoyed...
  3. Replies
    12
    Views
    29,747

    Truestone

    Guys

    I took a couple of quick shots of this tub, enclosure and vanity top I installed last week. This is called Truestone. It is an image of granite imposed onto a cultured marble panel. Looks...
  4. Replies
    15
    Views
    2,741

    Regarding bathroom 2 Why not make the shower...

    Regarding bathroom 2
    Why not make the shower 3x3. I think it would make the slope less of an issue. You could use the space for a cabinet faced linen closet, water heater or something.
    MTC
  5. Replies
    3
    Views
    2,383

    New product

    Guys

    I took a couple of quick shots of this tub, enclosure and vanity top I installed last week. This is called Truestone. It is an image of granite imposed onto a cultured marble panel. Looks...
  6. Replies
    2
    Views
    1,140

    Your tub should be level. For it to function...

    Your tub should be level. For it to function properly it needs to be level. I am in mostly new construction. Your builder should resolve this issue for you. Don`t let him cheap out on you and scab...
  7. Replies
    5
    Views
    2,003

    I always use a 40 mil shower pan liner. tmg

    I always use a 40 mil shower pan liner.

    tmg
  8. Replies
    14
    Views
    2,660

    You can still use a nail or pick to get in behind...

    You can still use a nail or pick to get in behind it and roll it out with a pair of pliers. Just take your time and get a little piece started and get the needle nose wedged in behind it. Then it...
  9. DIY, From here it is a question of money. You...

    DIY,
    From here it is a question of money. You probably wanna replace the plumbing which is gonna cost probably right at $500. labor included. Pick a tub,then get a cultured marble surround. I am...
  10. It is exactly the opposite of moving a tub drain...

    It is exactly the opposite of moving a tub drain to a shower drain.Bust out the concrete to where you need it and hope the drain runs under it . Place the drain where you measured it to the center of...
  11. Replies
    28
    Views
    3,893

    Tighten the screws holding the fitting to the...

    Tighten the screws holding the fitting to the backerboard. There should be three screws holding it. If you have enough room that is.

    TMG
  12. Replies
    3
    Views
    1,075

    Scat, Depending on the model of tub you...

    Scat,
    Depending on the model of tub you purchase, some come equipped with a removable skirt(panel). You can also get a cultured marble one and silicone it to the front of the tub if it is open. It...
  13. Replies
    5
    Views
    1,837

    It`ll hold water in the corner. Ya gotta take it...

    It`ll hold water in the corner. Ya gotta take it back out and try again. Make sure you bed it in something if it is an acrylic tub. You might run a band around it to keep the edges straight. The...
Results 1 to 13 of 14