Search:

Thanks for all of the input.

Jim are you saying that I place the box in the return I can not run the Wires up the stud in the Return unless they are in a metal conduit?

and if that is the...

Hello all,

Looking for a little advice, I am going to be installing a solid piece single threshold shower pan. It is produced by a company here in Ohio called Rainbow.

The specifics of the...

Agreed. What if I partitioned the Cold Air return and built a 2x4 box around the switches and wiring, narrowing the passage used for the cold air return. does any know of a specific requirement for...

I am in the middle of a bathroom remodel. As part of the remodel I am changing the swing of the door and will need to move the switches from one side of the door to the other. Not a big task as I am...

HJ,

Thanks for the input, when you say the "Proper fitting", what would that be? Are you recommending a double Y fitting instead? If so what is the Benefit of the double Y vs. the risk of using...

Ok all here are a few pics of the drain system that I have installed.

You will notice I have also routed in an additional vent from the left for a toilet that was moved to that end of the room. As...

The blue routing from the original pic is what I have put together, I will post a pic or two tomorrow night after I put it in. Thanks again for all of the input all.

I have a toilet that I am attempting to move from one side of a wall to the other. The current set up has a drain running up the outside wall of the house from the basement the drain makes it to the...

HJ,

Thanks for the input, One quick question. When you refer to the orriginal design are you refering to a situation where the drain is routed at the base over the the center of the two sinks...

I am currently in the process of a master bath remodel, and I have a question regarding the venting / drains for the new double sink vanity that I plan on using. I will be moving the vanity to the...