Search:

Thanks for that, 1/8 does seem to be the general opinion, I do seem to remember them having quite a fine thread!

Thanks

Problem is that I am in the UK so cannot measure, and wanted to order parts before arriving in the US.....perhaps I can ask a neighbor to measure the outside diameter of the existing ones!

It is my home in Michigan US and has baseboard heating with a WEIL McLEIN Gold series 4 boiler......

Thanks cwhyu2.......do you know if one size is more common than the other?

Hi everyone,

I need to replace the automatic air vent valves in my domestic hydronic heating system and was going to use the Watts FV-4M1 valves.....I noticed that there are 1/8" and 1/4" sizes,...

Its not always good to jump to conclusions....perhaps an appropriate name (speedy) toooo speedy! I WAS NOT THE FIRST POSTER OF THIS SIMILAR QUESTION! but thanks for the advice, I asked the question...

Hi,

I Have had a 200amp panel fitted approx 2 years ago and notice that the neutral and ground terminal blocks at the panel are joined as one, the ground wires and white wires are connected...

Thanks guys for all your inputs, I will most likely go with option 3 as it does not seem from your comments that the ground is too important, and does not seem so important if not grounded when in...

Hi,

My and my neighbors property both share an Artesian well and can swop who's power connects to the well via a changeover switch at the well head (also has a central off position).....this is...

Hi everyone,

I have a hydronic system which has a slight leak under the WEIL-McLAIN GOLD GV Series 4 boiler (contains Cryo-tec), has anyone got any ideas to a common place for the leak on this...

Hi I understand some of your points......surely it would be an advantage for both parties when it comes to selling your property to have your own well, also on sharing a well you are not in charge of...

Hi, At present we are on a shared Artesian well (on neighbors land) with our neighbors and wanted to get a rough idea on how much it would be to have our own well drilled.......we already have the...

Yes the square end is the top of the screwed plug (where the wrench would go).......so are you saying that I can use ptfe tape or thread compound

Hi, just trying to find out what method you use to seal 3" rodding access threaded connections (with square end) within a drain set up, not sure if PTFE tape is ok or not......

Ones I have looked...

How come the pump did not burn out I wonder?

I was thinking that there maybe an overflow underground from the well straight into our sump as it has a plastic fitting...would this be possible do...

Sorry, I mean the pump is not above ground.....the head of the well is approx 2' above ground.

Hi, speedbump

Unfortunately, do not have that information, did try and look at the local records a few months back but could not find any information.....it is a submersible as it is not above...

Thanks hj

Sounds as though this would be cheaper than the first reply, any idea of price for this way?

Hmmm, in regard to where the water went, we are the lower of the 2 properies with the...

Do the pumps go above one another?

Sounds expensive....any guidance on price?

Hi,

Hope someone can help,

We share an Artisian well with a neighbor (quite common I know) it appears that the water supply splits under the ground, then runs to each of our properties......our...

Hi,

Hope someone can help,

Was advised by a retired plumber that the Honeywell integrated boiler control S9301A1001 on our Weil Mclain furnace has a recall on it....could anyone out there...

Hi,

Have a property in Michigan that has a basement with sump pump, this is pretty active coming on approx every 7 minutes or so for about 20-30 seconds. Lots of questions (sorry)

I live in...