(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: tritontr; Keyword(s):

Search: Search took 0.10 seconds.

  1. Thread: A coil

    by tritontr
    Replies
    5
    Views
    1,512

    You have only 8 months left if you want an R-22...

    You have only 8 months left if you want an R-22 system after that 410A or similar only. Tick-Tock
  2. Replies
    8
    Views
    1,569

    Look at the Compact Cadet 3 from American Standard

    Look at the Compact Cadet 3 from American Standard
  3. Replies
    12
    Views
    3,563

    Crimper

    I have not seen the one that uses vice-grips. This is a Close Quarters tool you put the crimp ring between two bars then tighten two bolts evenly to make the crimp. I have used it in places where the...
  4. Replies
    12
    Views
    3,563

    crimping tool

    You can buy a pocket crimper or close quarters crimper for under $40.00 for emergencys. I would keep a supply of PB to Pex fittings in the sizes of pipes in your house. This is for you to make...
  5. Replies
    12
    Views
    3,563

    poly to pex

    Go to www.mobilehomerepair.com and you can click on articles and it will show you how to connect from Poly to Pex. There are specific fittings that transition from Poly to Pex. They come in several...
  6. Replies
    8
    Views
    3,333

    Mark go to www.mobilehomerepair.com click on the...

    Mark go to www.mobilehomerepair.com click on the (forums) category then near the bottom of the page click on (off topic discussions) then the post (Pex installation handbook) download the link it...
  7. Replies
    3
    Views
    749

    Expansion Tank

    New residential 40 gal. electric water heater with new Watts expansion tank. Due to WH location the expansion tank is installed with a T- fitting in the cold water line a couple of feet above. When...
  8. The problem with PB piping as I understand it was...

    The problem with PB piping as I understand it was when the fittings were plastic not copper. I have a 96 model with no problems so far. Just keep a supply of Pex to Poly fittings and invest in a good...
Results 1 to 8 of 8