(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: ArayT; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.13 seconds.

  1. Thanks Gary, That will be easier. Do you think...

    Thanks Gary, That will be easier. Do you think this will solve my problems? I also read that my water softener could be causing this due to the reaction between softened water and the anodes. If...
  2. Thanks for the link! Looks like its time to add...

    Thanks for the link! Looks like its time to add hydrogen perozide to my water heater.
    Ray
  3. Rotten Egg Smell after replacing anode rods in water heaters

    I posted this in the Water Softener Forum earlier, may have been the wrong location. After reading many post can someone tell me what type of test I should have run to determine if I have a bacteria...
  4. I replaced the factory alum rods w/ magnesium...

    I replaced the factory alum rods w/ magnesium rods. Are you saying I should totally remove the rods? What effect will this have on my water heater?
    rt
  5. Still Rotten Egg smell after replacing aluminum rods

    Can someone tell me the source of my rotten egg smell. I replaced the aluminum rods in both water heaters & I Still have that smell. I ocassionally get the smell downstairs (which is served by a...
  6. Thanks Gary, I was hoping you would reply. I...

    Thanks Gary, I was hoping you would reply. I went to you site and tried to work thru the many calculations you have. Iíll need wife to find water test results. I cannot remember the iron or...
  7. Thanks Again, I Hope the extra regen takes care...

    Thanks Again, I Hope the extra regen takes care of the problem. I'm still puzzled about the bad taste. I have not introduced iron out in several weeks so I don't believe it was iron out. The...
  8. Many Thanks, I'll run it thru extra cycles...

    Many Thanks,
    I'll run it thru extra cycles tomorrow. Is there a correct/ or incorrect water level for the brine tanks? What do you think made the water taste awful? Something had to be in it.
    ...
  9. Help w/ Cloudy Water after changing softner settings

    I have a fleck 7000 that was not using salt (approx 1 bag ever 4-5 months). After inspecting the pick-up tube in by salt tank I found it was approx 2-3 inches off the bottom and when it filled only...
  10. Replies
    2
    Views
    1,894

    Fleck 7000 Problem

    Got it fixed!! Idiot me mistook the PM light for the flow light.

    Need advise on programming valve. I Try to enter extended program mode (via v^ simu for 5 seconds at 12:01pm) the programming...
  11. Replies
    12
    Views
    2,504

    Thanks for all the help and advise. I'll be...

    Thanks for all the help and advise. I'll be changing it out shortly.
    Thanks Again, RT
  12. Replies
    12
    Views
    2,504

    Do you think its a manufactured defect? If so...

    Do you think its a manufactured defect? If so should A/S would make it good? Or is it just typical for this model?
  13. Replies
    12
    Views
    2,504

    Not sue how to post picture. I placed it in my...

    Not sue how to post picture. I placed it in my shared album. Will this work?
    Thanks
  14. Replies
    12
    Views
    2,504

    I tried holding the handle down, no difference. ...

    I tried holding the handle down, no difference. I have not pulled the toilet to check the wax seal. I don't believe its blocket but it looks like pulling it might be my last option. I was hoping...
  15. Replies
    12
    Views
    2,504

    The bowl is filling up (the fill tube is in...

    The bowl is filling up (the fill tube is in place).
  16. Replies
    12
    Views
    2,504

    Thanks for the response... I'm not sure what you...

    Thanks for the response...
    I'm not sure what you mean by double flush. I lowered the float to try and get more water into the bowl. You can pour water down the bowl while its flushing and it works...
  17. Replies
    12
    Views
    2,504

    Problems w/ American Standard Retrospect Toilet

    Has anybody had any issues with an American Standard Retrospect Toilet? I purchased one 2+ years ago and just started using it (it was in an upstairs area that was not finished). The problem is it...
  18. Replies
    3
    Views
    1,058

    Thanks for the responce. The problem because of...

    Thanks for the responce. The problem because of the location and the existing wiring the switch will need to carry ther pump load. Its a liberty pump 1/2 hp 115 volt.
    Thanks rt
  19. Replies
    3
    Views
    1,058

    Best Float Switch

    Who and what type float switch (mercury / magnetic??) is recommended for a sewage pump tank?
    Thanks
  20. Will Do. Thank You, Thank You, Thank You again...

    Will Do.
    Thank You, Thank You, Thank You again for all the help!!!
    Ray
  21. That make since. I do not believe I've broken...

    That make since. I do not believe I've broken anything, nothing has been moved. I'll change the piping tomorrow and clean out the valve. Any advice on cleaning the valve and would you recommend...
  22. Thanks for the advise. Its piped correctly. I...

    Thanks for the advise. Its piped correctly. I did not have my system in bypass, I hope I did not mess up. I did flush everything after. Does Gary have his email address posted?
    Thanks Again,...
  23. Gary or Someone Please help, resin in drinking water

    My resin is leaving my softener. What causes this and how can it be fixed? I trippled checked the piping. I was running water from a hose bibb that is located in front of my softener and the water...
  24. Replies
    2
    Views
    826

    Can I check Resin to see if its bad??

    My system is a fleck 7000, 40k thats only 8-10 months old. Is there a way I can make sure my resin is not ruined? A few weeks back I realised my softener was not using any potassium, it had bridged...
  25. Replies
    0
    Views
    1,642

    Controlling Tea Weed (Prickly Sida)

    Does anyone know how to stop tea weed? I'm trying to establish a grazing area of bahia grass. I sprayed it several times last year w/ 2,4-d, this knocked it back. This year I harrowed it then...
Results 1 to 25 of 28
Page 1 of 2 1 2