(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: wwilson1; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    1
    Views
    1,561

    Caroma toilet questions.

    I'm looking at using the Caroma Caravelle 270 or the Tasman 270 to replace a toilet that needs a 10" rough in. Another option is the American Standard Cadet 3459 (10 rough in), but the Caroma does...
  2. Replies
    2
    Views
    3,860

    Tub faucet and shower head location?

    Need more help! I'm installing a new delta tub/shower valve, tub spout and shower head.
    Questions:
    1. How high should the showerhead be? It will be about 72" from the bottom of the tub to the elbow...
  3. Replies
    2
    Views
    2,111

    Bathroom sink and toilet supply plumbing.

    I bought the shut-off valves and stainless steel braided hose to connect the galvanized plumbing in the wall to the bathroom sink hot/cold and the toilet. The ball valves I bought are female...
  4. follow on tub faucet

    mark and jimbo,

    Thanks for the help. One more question:
    Will the male IPS threads (straight) on the Delta work with the galvanized couplers (NPT taper I presume)? I plan to use teflon tape for...
  5. Need help installing a new tub/shower faucet.

    All,

    I need some advice for installing a new tub/shower valve. The first two photos show the existing arrangement, and the last photo shows the new valve. I want to use galvanized pipe and...
  6. Not a weekend project anymore...subfloor questions...

    Ive been working on preparing a small bathroom for a tile install. The subfloor is plywood over I-beam type joists. There is a finished basement below. The joists are 16 on center and assuming...
  7. Replies
    6
    Views
    3,110

    I started thinking I may want to replace the...

    I started thinking I may want to replace the floor some day (this is my 1st tile project) so...would it be more prudent to tile up to the vanity, and if my tile job goes south I can take it out w/o...
  8. Replies
    5
    Views
    2,568

    The house was built in 1979. The pipe and flange...

    The house was built in 1979. The pipe and flange look to be black PVC and the part that is screwed down is painted-pressed-sheet metal. The particle board around the base is soft (ruined) due to some...
  9. Replies
    1
    Views
    2,510

    Bathroom tile installation.

    Im preparing a bathroom for tile installation and Ive been removing a 3/8 layer of glued down particle board that had vinyl floor attached to it. The particle board is attached to plywood. It...
  10. Replies
    6
    Views
    3,110

    I'm in the same boat, and want to make sure I...

    I'm in the same boat, and want to make sure I understand your suggestion. You are saying it is easier to go ahead and tile the floor and run the tile into the area where the vanity cabinet will sit...
  11. Replies
    5
    Views
    2,568

    Dealing with toilet floor flange in remodel

    Im working on a bathroom remodel. The last couple evenings Ive been chiseling/scraping a 3/8 layer of glued down particle board off of the plywood sub-floor. I found a pneumatic automotive...
Results 1 to 11 of 11