(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: blove1344; Keyword(s):

Search: Search took 0.16 seconds.

  1. Replies
    6
    Views
    830

    Thanks Jim, It is the diverter! I'd never...

    Thanks Jim,

    It is the diverter! I'd never thought of that. I was ready to swap out the valve.
    Thanks again!
  2. Replies
    6
    Views
    830

    We are on a well system. I checked the tank...

    We are on a well system. I checked the tank pressure and it reads 50psi.
  3. Replies
    6
    Views
    830

    noise in shower head

    My newely installed tub/shower has a squealling noise when the shower is turned on.
    It is a Moen valve and shower head and there is a loud squealling noise usually after
    the water has been on...
  4. Thread: pipe squeal

    by blove1344
    Replies
    3
    Views
    233

    I installed another new shower head. This one has...

    I installed another new shower head. This one has adjustable flow. It squeals as bad or worse than
    the original, in any flow pattern. The control valve is new as well as the copper pipe from the...
  5. Thread: pipe squeal

    by blove1344
    Replies
    3
    Views
    233

    Thanks, I'll try replacing the shower head first....

    Thanks, I'll try replacing the shower head first. Will let you know how it goes.
  6. Thread: pipe squeal

    by blove1344
    Replies
    3
    Views
    233

    pipe squeal

    Just completed my bathroom remodel. The shower squeals for a few minutes after turning on the water then the squeal goes away. The noise
    sometimes starts right away but usually after it has been on...
  7. Replies
    4
    Views
    2,589

    Sani-Seal Toilet Gasket vs Wax Ring

    Has anyone a time proven experience with the new SaniSeal toilet gasket?
    I am about to install a new toilet and am thinking about using the new seal.
    Any advice?
    ...
  8. Replies
    2
    Views
    588

    Thanks. It will take some time but I think in the...

    Thanks. It will take some time but I think in the long run thats the best way of doing it. Thanks for the confirmation.
    I needed someone with experience to give me some confidence.
  9. Replies
    2
    Views
    588

    over thinking tub installation?

    I'm in the process of installing a Sterling tub and surround. The tub is ready to go in but I'm having issues.
    In dry fitting the tub I found one corner slightly off level and should be raised a...
  10. Thanks John, Sounds good. Does that mean that...

    Thanks John, Sounds good. Does that mean that some of the legs will be embedded in the mortar?
  11. Thanks Jim. That's the way I'll do it.

    Thanks Jim. That's the way I'll do it.
  12. Thanks Gary, There are a lot of legs under this...

    Thanks Gary,
    There are a lot of legs under this tub and I can't for the life of me figure out how I would spread mortar and not have at least some legs imbedded
    and end up with a lopsided tub....
  13. I have a question about the mortar bed also. I am...

    I have a question about the mortar bed also. I am going to install a sterling tub and surround and it is recommended to use a mortar bed even though
    the floor is level. My question is: Is it ok to...
Results 1 to 13 of 13