(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: cpmarks; Keyword(s):

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    1,717

    So the heat pump would be to heat the air? I am...

    So the heat pump would be to heat the air? I am looking to heat the slab but sounds like I might be better off with a real boiler and a slab sensor. Thanks for the input.
  2. Replies
    6
    Views
    1,717

    Tankless WH Radiant Floor Heat

    I am currently heating my attached garage with a 4KW electric workshop heater. I have tubing in the floor for radiant heat and I want to take advantage of radiant floor heat. Please note electricity...
  3. Replies
    36
    Views
    38,481

    If the top of the flange is level with the...

    If the top of the flange is level with the finished floor will a standard size wax ring be good enough or should a thicker one be used? Is it possible that the thicker one will have too much wax and...
  4. Replies
    4
    Views
    1,069

    I did the bucket fill test after turning off the...

    I did the bucket fill test after turning off the pump, draining down the tank, leaving the drain valve open with the hose end in the pail. At that point I flipped on the breaker and started my...
  5. Replies
    4
    Views
    1,069

    I tested the gpm of the pump by filling a 5...

    I tested the gpm of the pump by filling a 5 gallon pail. I could fill the pail in about 20 seconds, so there seems to be no shortage of flow from the pump. I think it must be that since I am opening...
  6. Replies
    4
    Views
    1,069

    Pump or Pressure Tank Problem

    I have connected my pressure system at my new house. We are using our existing submersible pump and well from our previous mobile home but are using a new pressure tank. The system will kick on at...
  7. Thread: Pex Design

    by cpmarks
    Replies
    2
    Views
    643

    Pex Design

    I am running the supply lines in my new house and cannot decide which way to to run my lines. I am thinking about doing it one of the following ways.

    a) Use a manifold system that would run a 1/2"...
Results 1 to 7 of 7