(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Fubar411; Keyword(s):

Page 1 of 6 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    6
    Views
    1,477

    I have a vent for the shower already, sorry it...

    I have a vent for the shower already, sorry it wasn't pictured. So if I WYE between the toilet and the drain it should be ok? Just abandon the 90 with the side inlet?

    Thanks!
    -Rob
  2. Replies
    6
    Views
    1,477

    Now where is the fun in that? Do they make WYEs...

    Now where is the fun in that? Do they make WYEs that have a street bend type ending at the base? This is going to be tight.

    Thank you for your reply!
  3. Replies
    6
    Views
    1,477

    Small bathroom DWV

    This is my 2nd floor bath. I'm hoping to do the following, but I wasn't sure if this fitting can be used. It is the 90 3x3x2 with the 2 coming in on the corner.14752

    All fixtures are within 3 or...
  4. Thanks all, I'm on it.

    Thanks all, I'm on it.
  5. Are either made in the USA? I am currently...

    Are either made in the USA?

    I am currently looking at Rheem 42VR50-40F High Efficiency Natural Gas Water Heater, 50 Gallon, but reviews say Mexico.
  6. Recommendation for residential gas water heater

    Doing my parents' water heater, gas is available. What is preferred these days that is available to a consumer? I know to avoid the big box stores, but don't want to break the bank.
    Thanks,
    Rob
  7. Funny though

    Here in St Louis, you can't have your main shut off be a 1/4 turn ball valve. I heard the justification is that would be too hard on the street connections. But hey, it is only the most important...
  8. Replies
    7
    Views
    2,141

    As long as the tub is draining there isn't a...

    As long as the tub is draining there isn't a "problem", it shouldn't drain into the walls.

    But look at the diagram provided, this is fairly straightforward. You have a hollow cylinder that blocks...
  9. Replies
    3
    Views
    969

    The specs demand/call for 3/4" supply, which I've...

    The specs demand/call for 3/4" supply, which I've done, doing the rest in 3/4" isn't difficult. I will use the drop ells as well.

    The water heater is a 50gal electric that is on its last leg. ...
  10. Replies
    3
    Views
    969

    Multi-head showers

    I'm installing a multi-head shower at my sister's this weekend, marketing says it is a vertical spa. The install directions are pretty specific about balancing loops and placement. I've read on...
  11. Replies
    12
    Views
    3,435

    Is this on an exterior wall? I'm lazy, I'd be...

    Is this on an exterior wall? I'm lazy, I'd be inclined to run the copper in the vanity if it was staying, if not put it in the wall.
  12. Replies
    23
    Views
    2,766

    What people have said before, drain the whole...

    What people have said before, drain the whole system, clean the inside and out several times over...then clean it again, hit the fitting with heat until the solder starts to stick. There's plenty of...
  13. I like your choice of carrera marble.

    I like your choice of carrera marble.
  14. Replies
    12
    Views
    4,365

    Not a plumber and not very knowledgeable... You...

    Not a plumber and not very knowledgeable...
    You need 2" for that shower, unless it is a bathtub shower.
    I think the vent on the cleanout is usless, but I could be wrong.
    I think you need a 3" vent...
  15. Replies
    25
    Views
    4,417

    You're ok, just figure out the true OD of the...

    You're ok, just figure out the true OD of the pipe you have and go to a real plumbing supply store. Also pick up some clamps from the supply store to support your pipes above the PVC, so the PVC...
  16. Thread: 3/4" cross

    by Fubar411
    Replies
    1
    Views
    669

    3/4" cross

    I'm putting in a moen vertical spa, and according to the directions, I use the one output plugging the bottom outlet) from the 3371 valve and have it feed three 3/4" volume valves. Theres only a...
  17. Replies
    20
    Views
    4,756

    Buy 12/3 for the countertop circuits, use a...

    Buy 12/3 for the countertop circuits, use a ganged 20amp breaker. For the dishwasher/waste disposal, run a 20amp circuit, but break the tab between the two receptacles. Have one receptacle switched...
  18. Replies
    16
    Views
    2,417

    Please remember to use unions.

    Please remember to use unions.
  19. Replies
    8
    Views
    2,191

    Well, your justification for not taking out the...

    Well, your justification for not taking out the cabinet is that coupling on the PVC. You probably know that you can simply cut that flush and make the hole a little bigger for when the coupling is...
  20. Replies
    13
    Views
    4,665

    I'm amazed at how bad the current black pipe...

    I'm amazed at how bad the current black pipe fittings and threading are. Not to mention how expensive it is. I picked up 4' of 3/4" for $12 the other day, neglecting to look at the threads. When I...
  21. Replies
    11
    Views
    2,766

    So, I guess for HJ because I saw him say it...

    So, I guess for HJ because I saw him say it before. Is the 3371 a problematic valve? I found a kit I like, the Moen 270.

    Thanks,
    Rob
  22. Replies
    11
    Views
    2,766

    Ok, I like the Moen "vertical spa" systems, but a...

    Ok, I like the Moen "vertical spa" systems, but a quick search on here told me the Moen 3371 valve is hard to service.

    I have no problem running 3/4" supply to the valve.

    I also like the...
  23. Replies
    11
    Views
    2,766

    How about this:...

    How about this:
    http://www.moen.com/search?search_scope=0&search_terms=t4111
    it is Moen T4111 Kingsley Trim

    I assume a transfer valve could be used for running two showerheads, althought not...
  24. Replies
    11
    Views
    2,766

    Thanks for the reply. Also, this will be for a...

    Thanks for the reply. Also, this will be for a dual shower head system, if there is a good way to do this without individual shut offs for each shower head.
  25. Replies
    11
    Views
    2,766

    High quality shower valve

    I was wondering what the recommended shower valves are? I have heard mostly Moen and Delta on here, but which specific lines? I'm looking for shower only (no bath), with a classic chrome look to...
Results 1 to 25 of 141
Page 1 of 6 1 2 3 4