(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: schustermarie54; Keyword(s):

Search: Search took 0.11 seconds; generated 25 minute(s) ago.

  1. Replies
    11
    Views
    5,370

    You’re talking about a fairly rickety old drain...

    You’re talking about a fairly rickety old drain system so the answer isn’t easy. If the original problem was a non-draining drain line the plumbing contractor may be at fault. Maybe I’m wrong, but...
  2. Replies
    4
    Views
    4,626

    I've seen commercial floor drains built to code....

    I've seen commercial floor drains built to code. What they look like is a large square hole in the garage floor with a grate over the top of it. A stand pipe comes up in the middle of the hole, flips...
  3. In my opinions, forget the M. It is just too thin...

    In my opinions, forget the M. It is just too thin walled.

    Also in my opinion copper is for homes of the past and there is no good reason to use it in new homes. Look at the posts here for frozen,...
  4. This gets way nerdy on the pump/plumbing of the...

    This gets way nerdy on the pump/plumbing of the Reservoir System. Beware. If you are super nerdy, this is where you can jump in and start making this system better!!

    Your reservoir system is a...
  5. Replies
    4
    Views
    1,620

    Maybe someone dropped a huge bomb with a bird...

    Maybe someone dropped a huge bomb with a bird sitting on the edge of the pipe and passed out from the fumes. All joking aside though i would imagine one sniff of the top of the vent gives a pretty...
  6. You could try a local plumbing supply house. Ours...

    You could try a local plumbing supply house. Ours carries a few different brass bypass valves for softeners.

    Or......just plumb a bypass in yourself. There is a distince advantage to this if/when...
  7. I once had the same problem. I put a piece of PCV...

    I once had the same problem. I put a piece of PCV (it was either 3/4 or 1 inch...don't remember) into the drain hose and used a pipe clamp to hold it. That constricted the drain size and reduced the...
  8. Replies
    8
    Views
    1,270

    I assume you have checked to see that the air gap...

    I assume you have checked to see that the air gap is plumbed the right way? It's hard to get it reversed but I've seen it done through creative plumbing.

    Try pulling the hose off the disposal and...
Results 1 to 8 of 8