Search:

Has anyone used a MDI VS-120R1R9L-01B Vertical Float switch for a sump pump?

I have a Rhombus VerticalMaster and it has stuck on the side of the sump basin causing a flood. This MDI Vertical...

My Zoeller Sump is pumping into a Y and the bottom of the Y has an end cap with the 3/16" hole pointing (vertically) down at the water. It was installed by the plumber when the house was build. Is...

It sounds like there is no disadvantage to having two 18"x24" sump basins. Am I correct?
I would like use two sump pumps because I am pumping so close to the basement floor. Either 1/2 hp pump...

Is there a disadvantage to having two 18"x24" sump basins next to each other if they are connected by a short pipe?

The two sump basin solution might be easier to achieve given the ammount of...

Where should the top of the sump basin be?

My sump basin is about 6" below the (top of the) basement floor and about 2" below the bottom of the concrete slab. I would like to raise the sump...

The 10 minutes of pumping is to clear the top 1/2 of my sump basin. I have moved the pump up so that it starts near the top of the basin and stops just below the two 4" intake pipes. These pipes...

Thanks for your help

I am not a plumbing professional but have a 4 year old house with a jacuzzi. the takagi TK-2 tankless has provided hot water for the house including the jacuzzi. Does your jacuzzi have 3/4" inflow...

I have been looking for a larger sump pump basin but not a deeper basin. I have the standard 18" diameter by 24" deep basin. I would like a WIDER basin to help increase the pumping time but not...

The pit is a standard 18" diameter by 24" deep. I am sitting on a lot of water partially because of a large basement (44' x 77'). At the bottom of the pit, The pump runs continuously. I have tried...

Does anyone have experience with a Blue Angel Sump pump - BCAP50 1/2 hp cast iron sump pump. It has a intelli-sense switch that is microprocessor controlled and has a 3 year warranty (not 1 year as...