(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Smooky; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.16 seconds.

  1. In # 4 of the instructions it says to “attach the...

    In # 4 of the instructions it says to “attach the silver pressure reducer for high pressure homes.” If that was installed you might need to remove it or clean it out.
    ...
  2. Replies
    5
    Views
    144

    11.6.5. ……The inlet tee shall extend at least...

    11.6.5. ……The inlet tee shall extend at least 6 inches below the liquid level in the tank and extend above the liquid level to a minimum of one inch from the top of the tank. In no case shall the...
  3. Have you tried cleaning the aerator? Take the...

    Have you tried cleaning the aerator? Take the areator off and run the water to flush out the pipe might prevent it from clogging it up again. A different type of aerator might help too.
    ...
  4. Replies
    6
    Views
    113

    Most new shower faucets are set up so that if...

    Most new shower faucets are set up so that if someone flushes a toilet you do not get scalded in the shower. So if the cold water is shut off or is turned way down you will not get much hot water...
  5. Replies
    3
    Views
    79

    You have what is called a torque set closet...

    You have what is called a torque set closet flange. It is held in place by the three bolts. The toilet bolt that is missing is not broken off, it just came off. You should be able to reattach one...
  6. Replies
    5
    Views
    144

    The liquid level should be at the same level as...

    The liquid level should be at the same level as the bottom of the outlet not the inlet. The inlet will be 2-3 inches above the liquid level. Measure from the bottom of the outlet to the inside top of...
  7. My thought is with a different tail piece and...

    My thought is with a different tail piece and drain type of course it might work with the j-bend you have or the lo-bend p-trap as it is supposed to work. The deeper you go with the p-trap the slower...
  8. Why don't you run the water pipes up in the wall...

    Why don't you run the water pipes up in the wall and come out on either side of the drain? The shut off valves should be under the sink.
  9. Replies
    2
    Views
    78

    The seat washer is on the end of the stem. The...

    The seat washer is on the end of the stem. The other washer is the packing or the packing washer. It can be a graphite string or sometimes it is a rubber washer. It keeps water from leaking around...
  10. Replies
    6
    Views
    113

    Here is a link that might be helpful: ...

    Here is a link that might be helpful:

    http://common.csnstores.com/common/marketing/symmons/S-86-2_installation.pdf
  11. Is there a pop up assembly in that tail piece? If...

    Is there a pop up assembly in that tail piece? If there is not you may be able to get a different type of tail piece and make it work.


    http://www.hardwarestore.com/tailpiece-668751.aspx
    ...
  12. Replies
    5
    Views
    144

    You should be able to find most of the answers...

    You should be able to find most of the answers here starting on page 38

    http://www.healthy.arkansas.gov/aboutADH/RulesRegs/OnsiteWastewaterSystems.pdf

    I cut and pasted a section from the code...
  13. I would remove a little dry wall around the pipe...

    I would remove a little dry wall around the pipe and hope there was enough pipe to install a trap adapter at the wall. If there is enough pipe I would cut the pipe right behind the fitting then clean...
  14. Replies
    1
    Views
    170

    SunSpool Drain Down Valve Here are some links...

    SunSpool Drain Down Valve

    Here are some links that might help

    http://www.terrylove.com/forums/showthread.php?33816-Solar-Drainback-Water-Heating-System...
  15. You could use the vent as an overflow to let you...

    You could use the vent as an overflow to let you know when the tank is full or you may need some type of float valve to shut the water off when it is full.
  16. Kirill I’m not sure about the clean out...

    Kirill
    I’m not sure about the clean out requirements. I would 90 and come straight out the wall because that way it is a lot easier to finish the wall and build the cabinet. The trap that you have...
  17. Replies
    4
    Views
    133

    The arrow is pointing to a worm gear hose clamp,...

    The arrow is pointing to a worm gear hose clamp, not a check valve.
    ...
  18. Replies
    4
    Views
    158

    Might be a bad Air Admittance Valve (AAV). I...

    Might be a bad Air Admittance Valve (AAV). I picture of the plumbing under the sink might help
  19. I would cut off the 45, y and pvc p-trap and...

    I would cut off the 45, y and pvc p-trap and change it to 90 degree straight out the wall. I would relocate the oversize nail guard at the base to the support post and install the proper size at...
  20. Replies
    20
    Views
    409

    Humidity does affect odor so when it rains and...

    Humidity does affect odor so when it rains and the humidity is higher you may notice the odor more. The picture of the plumbing looks good when I invert the screen. I know above you changed the AAV...
  21. Wall hung toilets do have a weight limit. Several...

    Wall hung toilets do have a weight limit. Several local hospitals that treat bariatric patients have had to add supports to their wall hung toilets.

    http://www.bar-industries.com/
  22. I think this is a first floor bath room. It looks...

    I think this is a first floor bath room. It looks like that is a crawl space under the bath room to me. Looks like there is plenty of room to do it either way.
  23. Replies
    20
    Views
    409

    This might be where the problem is located. A...

    This might be where the problem is located. A couple photoes of how it is tied into the plumbing and how the drains run under the sink might be helpfull. Does the drain line from the dish-washer loop...
  24. Replies
    5
    Views
    164

    Somewhere you have got the hot and cold crossed....

    Somewhere you have got the hot and cold crossed. If there is a recirculating loop the check valve may not be located correctly or maybe it was left out. You have to feel the pipes with your hands to...
  25. Replies
    4
    Views
    152

    It may be a radio meter reading system which...

    It may be a radio meter reading system which allows the water meter to be read with out opening it up but just drive by your home with a truck with water meter reading receiver.
Results 1 to 25 of 481
Page 1 of 20 1 2 3 4