(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: mb-plumb; Keyword(s):

Search: Search took 0.12 seconds.

  1. OK. I'm convinced. Steel pipe it will be. ...

    OK. I'm convinced. Steel pipe it will be.

    Mike
  2. best pipe material for storm drain line buried near ground surface?

    I need to install a 3" storm drain line, but it will have to be near the surface because the surface slope is shallow and not very long. Soil on top of pipe will be about 4". I can use corrugated or...
  3. Yep, I'm done. Tried the wire saw technique with...

    Yep, I'm done. Tried the wire saw technique with no success. Counter top is small, but a little complicated with a back-splash on three sides. It'll cost more than $50 dollars, but won't break the...
  4. Well, I tried the chisels plus prying, and the...

    Well, I tried the chisels plus prying, and the problem is the formica starts to separate from the particle board. Pretty sure the adhesive is white, silicone rubber. Remember the clear version of...
  5. How to get laundry sink unstuck from counter top?

    I need to replace a cracked, plastic laundry tub. It's self-rimming and is mounted on a formica-covered counter. The original installation was in 1999, and they used a lot of caulk, which appears...
  6. Replies
    6
    Views
    1,044

    OK! Stubby slip nut wrench is something I don't...

    OK! Stubby slip nut wrench is something I don't have and need to get. I did a little searching and think you're referring to something like the Pasco 43915, right? Thanks for the info; you've been...
  7. Replies
    6
    Views
    1,044

    True, the entire bottom is open, but no matter...

    True, the entire bottom is open, but no matter what you do with the bidet separated from the floor, one last nut will have to be tightened via the back access hole once the bidet is put in place. ...
  8. Replies
    6
    Views
    1,044

    That might have helped, but only partly. The...

    That might have helped, but only partly. The access hole is at the back. In theory, if I knew exactly how high the drain fittings should be above the floor, most of of it could have been installed...
  9. Replies
    6
    Views
    1,044

    struggle to replace bidet faucet and drain

    I recently needed to replace an American Standard bidet faucet because it was leaking, and AS could no longer supply parts for that model. Faucet was on a Kohler bidet, which had a couple of...
Results 1 to 9 of 9