Search:

Most lumber yards and supply places are switching to the light weight sheetrock.
I believe most of the problems are from big box supply places....I would recommend you buy from a lumber yard or a...

Wambat.....That doesnt even look like the tyvek flashing too me.What i have always used is white. Tyvek flashing the sill material is different than the side and top material. Sill material goes on...

Hi DIY SG,
I would use 3/4"t&g plywood. Screw it down. I like to use decking screws.
The 1/4" hardi backer board will work if you install it in thin set. Use good quality thin set...Like Mapei or...

Yes...I wasnt totally sure about the blower...my Rannai hot air heaters are direct vent and use a blower for the exhaust gas.

Thats what i wasnt sure of.....if a direct vent had a blower for the exhaust side. It must flow out naturally because of the hot exhaust? Has there ever been any known problems with a direct vent?...

I currently have a State 510E propane fired Hw heater. The date on
S it is 1991 and i purchased the house in 1996. Within the past couple of years i noticed soot around the burner area and the flame...

I'll put my methods.....most of which are traditional....against any. If done right, you dont need all this new crap that they have out there today.
i have never had a call back from a tile job.

rrekih.....install the 1/2" water proof hardi backer board on top of the plywood. I would cement it down with karabond mixed with karalastic with a few screws so it doesnt move. Install your tiles...