Search:

Not planning on a swimming pool at this time maybe later, Going to cover inside with 7/16 osb board unpainted, I will end up with 5" of blown in insulation. Thanks for the reply

Built new shop 36 x 45 x14 tall, looking for ideas on the insulation, was thinking of 1 1/2 inch styrofoam against exterior metal siding with blown in insulation filling remainder of the cavity. Is...

If you installed a pressure balancing valve and havent turned the hot water supply on the valve will shut off the flow of water completly. But they will sometimes allow a small amount of water thru....

Redwood
Maybe they all think they are big D&^KS

Who said you need to install it. the building inspector ?

What size generator do you have, and what are you planning on running with it

Suck it up and call an electrician before the house burns down

The tab is to hold onto it while you smack it with a hammer to keep it from dropping into the drain. I usually take a flat screwdriver and start it breaking then lightly tap it with a hammer all the...

I would be looking for empty beer cans stuffed in the wall or heat register, because this guy was either drunk, stoned or blind. After seeing these pictures Im going to raise my prices for the high...

Whats the measurement from the studs to the center of the drain, its hard to judge but it doesnt like like its right going by the picture

I would ask the plumber to make the repairs needed to replace anything that was damaged, This is why they require licensed contractors to carry liability insurance, to protect the homeowner.

yes and yes

Is that what you call it ?

You left out trying to bankrupt this country

I failed an inspection for the very same reason, when I questioned the inspector on this He stated I know you guys have been doing it this way for ever but now they require a 16 inch long plate with...

What kind of furnance do you have gas or electric

where is the line going to

You also run a chance of cracking the cast iron with a torch

Ask the drywaller how they hang there sheets, most guys get paid by the board and the fastest way to hang drywall is to get a measurement to the center of the box and hang the drywall and then use a...

Has there been any work done lately

If you know the height that is needed for the vent install a pipe 2 times bigger then the vent pipe then you can get your slope and seal it after its installed.

The last time I checked this is a Country that still allows free speech, If am standard has a problem with people trashing there product they should fix the flaws and not try and silence the people...

Take a mirror so you can see inside the toilet and use one of the flexible claws that mechanics use and you can get it that way.

Sewage ejector pits have a cover that is air tight to keep the sewer gases from entering the house so when the pump fails it will show up as a clogged line, the toilet wont flush and water will come...

I have a ridgid 7500 with a 3/4 inch cable and broke off it off in the line because I feed it to fast. Replaced the tip and put a larger cutter on and 3 hrs later working slowly I finally cut thru...