Search:

What is the proper way to install the 120V "power lead" to suntouch underfloor radiant heating mats. The lead is 3 wires smaller that 14 awg with a woven metal jacket. The install instructions say...

Thanks for the reply...

cutting the flush/tank elbow would work if the problem was that the bowl was too close to the wall --- my problem is (was - I just got a 14" rough in old bowl that matches...

How do you measure the rough in dimension of an old toilet bowl itself?

I'm installing a two-piece (wall mounted tank) toilet in my 1895 home. A few years back I got a toilet from a neighbor that...

Thanks for confirming installing the flange on top of the tile..finishing the tile grouting today. Will then screw top flange into subfloor with 2" #12 stainless screws - then tighten down the 3...

I'm installing a Jones Stephens torque set cast iron closet flange and have a few questions. (See attached picture)

The floor is a 3/4" plywood subfloor with 1/4" CBU, suntouch mat, approx 1/4" of...

The problem is that the new drain location is close to being directly over a joist. Moving it 2" or so to get away from the joist throws off the whole layout of the bath (e.g 48" for the vanity would...

The drain was installed in 1969. I'm guessing the 1 1/2" for a shower was OK back then.

Thanks Bob M

I'm redoing my shower and the drain will likely be directly above a joist or just on the other side of the joist from the stack/vent connection.

The existing shower uses what appears to be...

I’m remodeling my bathroom including an entire shower rebuild so all the plumbing in the bath will be redone as the existing piping is old corroded galvanized.

I have a question related to the...