Search:

Yeah, I'm guessing that would be the best solution. Only problem is that there is a side inlet off the Santee to the stack, raising everything up would require having to run that short, 2 inch branch...

Thanks for the input.
I could reroute the gas pipe. What i didnt mention and what is also going to be in the way is a large heating duct. It is justly barley seen in the bottem right corner of the...

I'm in the process of moving my toilet about 2 feet. After pulling up the floor boards, I found that my main gas pipe was directly in the way. My plan is to cut the copper pipe and put on a Fernco...

Remodeling the bathroom, currently gutting down to the studs and found this.
First: The tub drain and vent. The wye on the drain pipe is rolled slightly so that the section that drains the tub is...

Thanks. That is actually a third lavatory. But I will make all the vents the same height.

Horizontal vents will be at least 42" above floor or 6" above flood level of the lav.

Is the 90 Ell in the wall going to be OK?
3647

3648

3649

Looking for input on my DWV for 3 lav's.
Planning on everything being 2 inch cpvc. Assume 1/4 slope for the horizontal drain.
Questions:
1. The 90 elbow will be in a stud wall. Will that...

I'm looking to do the same thing in my bathroom. My local code follws the Interantion Plumbers Code. IPC allows a horizontal offset as long as it 6 inches above the flood level of the highest...

We are doing a big bathroom remodel and will be moving the bath tub to a new location. Since it has chipped and been reglazed previously and is chipping again we figured we would just replace it....

My husband and I are remodeling our bathroom and we would love to move a wall about 2 feet to open up the space. Problem is the 3" DWV Stack Vent is in that wall. Everything i have looked at has the...