(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: tlong_66; Keyword(s):

Page 1 of 2 1 2

Search: Search took 0.25 seconds.

  1. I replaced everythin from tank to bowl gasket, to...

    I replaced everythin from tank to bowl gasket, to locknut, seals and whole cannister assembly. It all came as a kit. No old parts were reused.
  2. I did let it sit without flushing.

    I did let it sit without flushing.
  3. Ok so this is what i have done in my...

    Ok so this is what i have done in my investigation of the problem. I flushed the toilet as normal and by that i mean with the tube sticking down the over flow. In about five minutes the water level...
  4. Gary i did that first before buying the...

    Gary i did that first before buying the replacement valve. I read the instructions for troubleshooting the problem. I cleaned around the seal, adjusted chain to make sure it was properly seated after...
  5. Kohler Cimmaron losing water in tank. Help!!

    Ok i have a problem and really need help. I have a Kohler Cimmaron that i have had for a year or so now. Up until a couple of weeks ago it worked fine with no problems. Now somehow water is leaving...
  6. Replies
    2
    Views
    1,003

    Problem with Kohler Cimmaron Toilet

    I've had a Kohler Cimmaron for a year or so now and it has worked great until recently. Every few minutes the fill valve opens and fills the tank then somehow it must lose water because it kicks on...
  7. Replies
    17
    Views
    1,752

    Ok guys Thanks for all the input. Here is an...

    Ok guys Thanks for all the input. Here is an update. I removed the toilet changing the seal, flange bolts and fill/flush valve. I used the main shut off to shut off the water supply. One minor leak...
  8. Replies
    17
    Views
    1,752

    Sorry i measured circumference. Diameter is 1/2...

    Sorry i measured circumference. Diameter is 1/2 inch.
  9. Replies
    17
    Views
    1,752

    Outside diameter is 1 inch.

    Outside diameter is 1 inch.
  10. Replies
    17
    Views
    1,752

    I want to replace the stop and the supply going...

    I want to replace the stop and the supply going to the toilet but have not found the right part at Lowes'. Since the new water supply will have a threaded end and not the "PB" end or pex i think you...
  11. Replies
    17
    Views
    1,752

    The toilet is located in a mobile home. It is...

    The toilet is located in a mobile home. It is grey poly butelyne.
  12. Replies
    17
    Views
    1,752

    What size water supply to use?

    First of all Thanks to all those to have given such good advice in my past posts. At the moment i have one last home improvement project on my list. That is to put a new seal under a toilet and...
  13. Replies
    4
    Views
    776

    I will try to post a pic. Not sure what good it...

    I will try to post a pic. Not sure what good it will do. It would just show the black plastic flange no cracks breaks or problems you can see.
  14. Replies
    4
    Views
    776

    Problem with toilet install

    I am installing a new Kohler toilet. One of the hold down bolts on the old toilet was so rusted i had to hacksaw it off. Then when i pulled the toilet off i had alot of difficulty removing the...
  15. By under pressure do you mean not shutting off...

    By under pressure do you mean not shutting off the water supply?
  16. Draining water heater

    Electricity was shut off and one hot water faucet was open. Should more faucets be open?
  17. Replies
    10
    Views
    2,264

    Buying new toilet. Need advice.

    I'm looking to buy my first new toilet. The only requirement i have right now is it has to have a round bowl due to space. I'm not looking for the Cadillac of toilets nor do i want to buy the...
  18. Draining water heater for element replacement

    When i opened the valve to drain my hot water heater only a very small trickle of water came out. I made sure the valve was open all the way. Is this normal? Everyone has told me about cleaning out...
  19. Replies
    5
    Views
    847

    Ok i was a bit confused. I was thinking the...

    Ok i was a bit confused. I was thinking the thermostat with the lower element was what i needed changed. Here is a pic of the upper element. So i just have to get another screw in type. Next...
  20. Replies
    5
    Views
    847

    Help with Upper water heater element.

    The lower water heater element is out in my water heater (Rheem brand) and i'm getting ready to change it (never done it before). Everyone tells me to change both the upper and lower at the same time...
  21. Replies
    9
    Views
    1,703

    Any ideas Jimbo?

    Any ideas Jimbo?
  22. Replies
    5
    Views
    1,139

    Which ladder is better?

    I'm looking to buy one of those multi-purpose ladders such as the Little Giant or Werner. Which is a better buy or better quality? The Little Giant is made in the USA and the Werner in China. I've...
  23. Replies
    6
    Views
    818

    Changing Water Heater Element

    I'm getting ready to change lower water heater element. Never done this before. I know basically what to do. Any words of advice or do's or don'ts i should know about?
  24. Replies
    9
    Views
    1,703

    http://i294.photobucket.com/albums/mm89/tlong_66/P...

    http://i294.photobucket.com/albums/mm89/tlong_66/P1000179.jpg
  25. Replies
    9
    Views
    1,703

    http://http://i294.photobucket.com/albums/mm89/tlo...

    http://http://i294.photobucket.com/albums/mm89/tlong_66/P1000179.jpg
Results 1 to 25 of 31
Page 1 of 2 1 2