Search:

I am installing a small oil fired boiler Benjamin OB1000 90,000 btu in my shop. Is there any reason I shoudn't use the brand new type b vent pipe for the chimney that I have just sitting there?? ...

I used Oxy pex 2 zones as per attached pic

Yes my statement was not correct full power at both elements.

When I attached the meter it went over 200 and I went on to something else.

One leg had 118 and the other leg had 86 (Back...

Thanks Maintenance guy we wer both typing at the same time I see both times are 5:12
Thanks for your detailed post.

I did have 19 ohms so you were bang on.

I was tracing back to the breaker...

Found the problem One leg of the power coming in overhead to the building Blew the insulink

On a GSW electric water heater that has two 4500 watt elements.

Both elements when the power is on shows full voltage when probed with the volt meter. 200

When I pull one wire off the element...

The outside "daylite" you see is actually the aluminum air foil going up the wall.

The concrete hasn't cracked yet But concrete in this area always cracks so It is going to happen anyway. No...

I have 2 zones (see pic) temp tonight is about 130 degrees outside tempature is 20 degree f

I did exactly what you are proposing.

I had a 18 x 30 building attached to my 30 x 30 gas heated shop.

In the 18 x 30 building I have 2 zones with approx 200 ft per zone.

It is heated with ...

The little green light flashes on a regular basis on the circuit board. Is that indicating every thing is normal??