(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: cwilliams2000; Keyword(s):

Search: Search took 0.10 seconds.

  1. Anyone run a Cuno/3M Iron removal system (Chem Free) with hydrocharger?

    I have one of these in my house, but it got installed without the hydrocharger which definitely limits what it can do for iron removal. I did a rebed on the media, and one immediate thing I got was...
  2. Ok so I clearly jinexed myself. So this...

    Ok so I clearly jinexed myself. So this morning I went down to find a small puddle under the well pipes. I really as surprised since I felt like I really took my time, cleaned every threaded...
  3. Tis done! Definitely a pain getting the water...

    Tis done! Definitely a pain getting the water out of the old tank but I was fortunate and all the connection points were able to be unscrewed cleanly, so I replaced the tank, tee and check valves...
  4. The final connection is a 1 1/4" to 1" threaded...

    The final connection is a 1 1/4" to 1" threaded male and that goes into a threaded shut off valve. If I can get that one apart then I just have to thread everything together which would be easier...
  5. Any last minute advice for well pressure tank change?

    I am planning to replace the tank I just realized last week had failed in my house (waterlogged). Its a pro source 50 gallon, I bought a well xtrol 62 gallon, I also bought a new T as well as the...
  6. There definitely isn't 12" around it, but perhaps...

    There definitely isn't 12" around it, but perhaps 8-10", I will check the size again since it may be 2" maybe I am wrong there. Thank you the reply though I will get a pic also
  7. Advice for installing a shower base with an offset drain

    I have a partially finished basement bathroom with a 1.5" drain line stubbed out underneath the surface level on the concrete floor. All the work from there is done, goes into an ejector pump that...
  8. How to assemble close nipples properly without a hex center?

    I am planning to replace a failed well pressure tank and part of the install will involve a few 1" close nipples. I have to be honest I have always dreaded these and always been able to find a hex...
  9. Replies
    5
    Views
    997

    I think I am having a hard time understanding how...

    I think I am having a hard time understanding how they work, it looks like they restrict flow to match what is being drawn and sounds good, but it would seem that the pump was intended to pump at...
  10. Replies
    5
    Views
    997

    Sizing a new well pressure tank.

    I currently have a Pro Source "50" gallon tank which I believe holds much less than that and my house has a lot of bathrooms, plumbing, etc and I have irrigation. I always have thought that it...
Results 1 to 10 of 10