(206) 949-5683, Top Rated Plumber, Seattle

Search:

Type: Posts; User: Noddaplumber; Keyword(s):

Search: Search took 0.13 seconds.

  1. I'm no expert on toilets, if anyone hasn't...

    I'm no expert on toilets, if anyone hasn't figured it out by my user ID. ;)

    Anyhoo, I had a Cadet 3 installed last month and a Champion 4 installed in January. I love my Champion 4. It's the best...
  2. Replies
    2
    Views
    1,058

    Thanks, Quagmire, I like the idea of not...

    Thanks, Quagmire,

    I like the idea of not sanding. :D It will be one less headache and far less mess to clean up.
  3. Replies
    2
    Views
    1,058

    Zinsser B-I-N and Venetian Plaster

    My entry, hall, and living room were covered in venetian plaster by the previous owner. I hate that stuff. Contacted Sherwin Williams who said to sand with a 220 grit sand paper and then prime with...
  4. Replies
    3
    Views
    23,406

    Measuring For A New Toilet

    I am purchasing a new toilet for my master bath this week. The plumbing supply said to measure from the wall to the hold down bolts. That measures 13 inches. So, I assume I can use a 10 or 12 inch...
  5. Kingsotall, HD doesn't sell them.......at least...

    Kingsotall, HD doesn't sell them.......at least not here but the dept manager called around to places for advice.

    From the base board to the center of the flange is exactly 9 inches.


    Thanks.
  6. Adapting a 9 inch Rough In to 10 inch Toilet

    Hello everyone. I just joined this forum but have been reading here for some time. I find myself in an odd situation that I haven't found an answer too so far.

    My house was built in 1970. I just...
Results 1 to 6 of 6