Search:

So if there is continuity between the neutral terminal and the chassis ground, then I DO NOT need to add a jumper. Is this correct?

I just got a hand me down Maytag range from a co-worker, model MER5765RAS. It came with a 4-wire cord, so I assume I can just wire the 3-wire cord from my old range to the new Maytag, with that said...

I ended up getting some Oatey No. 95 Tinning Flux, IT MADE ALL THE DIFFERENCE, I soldered up about 25 fittings in the Hot/Cold run and hot not one bad joint. Maybe if I did it more oftern I could...

I haven't had a chance to go back and give it another whirl, but I was thinking that I would get some Oatey No. 95 tinning flux. The website says it will never burn out (I'm sure this is a relative...

All joints were fitted prior to any cleaning or fluxing.



This is all brand new work except where I will tie into the old line. (hasn't been done yet, I was planning for that to be last...

Tonight I was helping a friend add some plumbing to his basement that he is finishing, we dry fitted all pipes, and I started to solder some of them, it is not often that I sweat pipes but have never...

It is copper, and it is not valved off from the rest of the house, where i am tying into the rest of the house will eventually be covered with drywall so I did not want to put a valve on then close...

I have added a new bathroom in the basement I am finishing and I was wondering when testing for leaks in the supply lines is it just as effective to do by turning water on, or should I take the time...

Crossover never crossed my mind, in this situation there is no good place for shut-offs, as I do not want enclose valves within the wall. I guess I should trade the one I got with one with...

This is my fisrt post although I have been reading for reference on here for a while, Great Site!

My question is: I am helping a friend add a bathroom in his basement and I have a couple things to...