Water Heater only Luke Warm
My water heater is only putting out luke-warm water. I put an OHM reader to the upper element and lower element at 1k OHM and both needles moved to infinity so I'm assuming both elements are ok. I just turned the heater on and the upper element is currently on but the lower element is not.
I should note that this happened right after I replaced my well pump. I could hear a dripping when I emptied the pressue tank and couldn't identify where it was coming from. Waht I think might have happened is that due to no pressure in the system, the hot water tank could have lost a bit of water. After I turned everything back on, the hot water got REALLY hot - hotter than it's ever been - then went luke-warm. Sounds like the upper element burning out, right? So why is the multi-meter still showing movement. Maybe it's the thermostat?