Fleck 6700XTR cycles seem incorrect
My 6700 doesn't seem to be going through the cycles correctly. I just ran it through its cycles by manually starting a regeneration, the purpose being to measure the BLFC flow rate. I have it Regenerant Flow set to Down Flow Double Back Wash, which has 5 cycles:
Down Flow Double Backwash:
1. Back Wash
2. Brine & Slow Rinse
3. Back Wash
4. Rapid Rinse
5. Brine Tank Fill
When it got to Cycle 4 it started flowing out the Brine Line
When it got to Cycle 5 it started flowing out the Drain Line, stopping the Brine Line flow.
This is a 6700XTR so it has an LCD that displays the cycle it is in. This is not my understanding of what is supposed to happen!!
I will try setting it to other Regenerant Flow modes and see if the seem to match the expected states. In the mean time, any ideas?
The manual is here : http://www.pentairwatertreatment.com...ow%2042132.pdf