Will this work for new P-trap for vanity?
House builder used solvent 90* downturn on 1/2" pipe to threaded connection as shown.
I was planning to use another 90* elbow, use 1/2" PVC to extend drain out, then use p-trap to turn the drain up towards sink and reduce pipe to 1/4"
Will this work?
I have my doubts since the water has to flow upwards now....but it does than in the P-trap anyways.
If not, I guess my fix to to cut off the solvent downturn and use a new solvent to threaded connection and extend drain out to the P-trap.