Ysbelman
New Member
I need some advice, i may have screwed up the way i positioned my rough in. This unit is by Moen, used for shower head and hand held spray. I'm attaching some pictures to show what is wrong with it. Basically the bottom handle is way out and has too much clearance, while the top nob bottoms out. These valves are pull/push, plus left/right. So when i push the top all the way in, it bottoms out on the trim piece I installed it somewhat to the spec, With the "plaster" plate, the unit is 3/8" inside the tile. Which is supposedly an option for thin walls (installing behind). The valves a sort of plumb, not perfect, but close. Any advice? Do i need to break the wall behind and redo?