Hdmstng
Member
I've been remodeling a bathroom and went to install the PVC toilet flange on and it set crooked! The right side is a hair off the tile but the left side is ~1/4 inch up off the floor. If I screw it down, the right side should be tight with the floor, but no way for the left side, still about 1/4" high. It is a PVC flange with a stainless steel ring that fits over a 3" PVC pipe. The 3" PVC pipe first into a 90 degree elbow.
Can I shim the right side of the flange with plastic shims? Will a normal wax ring work? Then also use the shims when I install the toilet?
Aren't there cutters designed to save the ID of the elbow and I can just cut out the entire thing and replace?
Any suggestion on how to proceed?
Can I shim the right side of the flange with plastic shims? Will a normal wax ring work? Then also use the shims when I install the toilet?
Aren't there cutters designed to save the ID of the elbow and I can just cut out the entire thing and replace?
Any suggestion on how to proceed?