I need some advice, I'm an average DIYer, but this has me puzzled. I installed 3 sinks in a salon last week. I had a licensed plumber install the drains, feed lines and vents. When I installed the sinks they did not line up with the drains in the walls and the drains were lower than the exit from the p-trap. So from the exit of the p-trap I installed a 45 on an angle twords the drain and then another 45 at the drain and ran a piece of pvc pipe between the two... This seemed to me to be the easiest thing to make the drain and the p-trap come together.
Yesterday the plumbing inspector showed up and said that this was "very, very bad", making the owner of the salon panic... what did I do wrong? He is saying that the drain is going up? I should have taken pictures when I was there today, and I will before I start over on Sunday.
Yesterday the plumbing inspector showed up and said that this was "very, very bad", making the owner of the salon panic... what did I do wrong? He is saying that the drain is going up? I should have taken pictures when I was there today, and I will before I start over on Sunday.