Washington state exam

Users who are viewing this thread

prospector

New Member
Messages
2
Reaction score
0
Points
0
Location
washington state
I took the state exam and failed it on the DWV & Water sizing.I've been a plumber for 25 years in Ca.I knew I was a little rusty on my sizing so I bought a 2009 code book.I studied the sizing pretty good and scored less than 50% on both sizing drawings.My problem is I was finding the answers on the straight runs ok,when I turned the corners 1 Hose bibb was added,then I couldn't find anything close on my answer sheet.According to the answer sheet the H/B was counted as 10 or more units,which threw off everything else off on the test,.I made a complaint but L&I never got back,I asked them to check the exam and I'm getting no response.Has this happened to any one else?I would really appreciate some advise thank you.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks