Cookie
.

I know just what your thinking Craig. (dam plumbers):o John

To repair the leak will require removing the check valve. At that point I would replace the check valve along with the two males. John

We would use a winged test plug with a hose fitting attached to the end. John

Its a Watts 009 RPZ. John

You will be far better off with the recirc loop connecting to the bottom of the heater with the circulator pulling the water back to the bottom of...

I am glad, lol. I was worried, :) Since, I know very little about them, then, I started to read about them, and saw an article about not wearing...

A bad valve or obstructed line on the discharge of the pump will cause the problem you're having. John

There is nothing made in between the two sizes. John

Don't know what to tell you. Pipe sizes are, and have always been 3/8"-1/2" and 3/4". Nothing in-between. Have you tried a 1/2" shower arm? John

There has never been 7/16" pipe. Pipe threads are tapered. What you are measuring is what is remaining of the threads of the broken shower arm. ...

As far back as I can remember shower arms have always been 1/2". It sounds like you have some pieces of the old shower arm in there. John

I don't know much about the glasses, but, I thought they might help seeing better if the computer was closer up. I hope I didn't say something wrong...

Now, for what this is worth, I know very little about it, I read where Google is coming out with, " Google Glasses," glasses with a computer in them.

Hi Bob! :)

Lee, that is great news! Nothing worse than having something to go wrong with your eyes. Good luck today, try not to worry and keep those positive...

A combo is the same as a Y and 45. Perfectly fine. John

Did, done. All my son did for me, with auto updates off, yep.

How you doing Lee?

Never got it Cacher.

From the age of the home you may have some lead drain lines serving the tub and toilet that need replacing. John

How funny, i thought at first you were talking about shoes. lol. It's a woman thing, eh.

I love people's inventions and it sounds like you done well! I am hoping for you Lee, and, sounds like your motivation will get your through it all,...

I think it's still growing. John

Change the sanitary tee to a Y and 45 and your good. John

That one screws on. There is a good chance that it will be too short or too long for your setup. The one you need is the Moen slip spout on the same...

There are tub spouts that just slip on. All you would have to do is cut the copper pipe off behind the fitting, clean the copper. Most are held in...

The RP1991 is the correct cartridge. The other one is a balance pressure cartridge which you don't have. John

That is the correct cartridge. When removing the nut that holds the cartridge in don't force it. There are here copper tubes that will break if to...