Register
Help
Remember Me?
What's New?
Articles
Forum
New Posts
FAQ
Calendar
Community
Groups
Albums
Member List
Forum Actions
Mark Forums Read
Quick Links
Today's Posts
View Site Leaders
Blogs
Advanced Search
Member List
kingsotall
Terry Loves Bellevue & Kirkland
425-649-5683, Top Rated Plumber 1-877-808-5683
Welcome to the number one plumbing forum in the United States and Canada! Check out the
FAQ
by clicking the link above. You may
register
above if you would like to post:. When you register and log in, you will see fewer ads.
kingsotall
Plunger/TurdPuncher
Find latest posts
Find latest started threads
View Articles
View Blog Entries
Mini Statistics
Join Date
08-17-2008
Last Activity
08-23-2009
12:19 PM
Blog Entries
0
Avatar
More
3
Friends
Terry
MACPLUMB 777
cwhyu2
0
Groups
You are not a member of any groups
Join Groups
1
Permission Groups
In the Trades
Recent Visitors
The last 9 visitor(s) to this page were:
99k
,
carnation
,
cwhyu2
,
Grayfeathers
,
gsrepa
,
Guitarchitect
,
lurch
,
Sue Geary
,
Terry
This page has had
3,794
visits
Tab Content
kingsotall's Activity
About Me
Friends
Tab Content
All
kingsotall
Friends
Photos
New Activity (
)
Older Activity
Yesterday,
07:46 PM
Terry
replied to a thread
Power vent or power direct vent recommendations
in
Water Heater Forum, Tanks
I like the Rheem units too. You might also look into tankless if you have a good enough gas supply there.
see more
4 replies | 43 view(s)
Yesterday,
07:37 PM
Terry
replied to a thread
Refridgerator suppy valve
in
Remodel Forum & Blog
It may be easiest to work out from the CPVC I would cut it back and start over. The threads where the shutoff threads down look to be fine...
see more
2 replies | 50 view(s)
Yesterday,
07:17 PM
Terry
replied to a thread
Toto Drake II vs Aquia - Ostomy bag
in
Toilet Forum discussions
I had the TOTO Aquia for a while, and then changed it for a TOTO Double Cyclone. The Aquia was pre Ostomy bag, and the double cyclone was during...
see more
3 replies | 94 view(s)
Yesterday,
05:47 PM
cwhyu2
replied to a thread
Toilet flange height
in
Plumbing Forum Discussion & Blog
Bottom of flange on top of finished floor.
see more
3 replies | 49 view(s)
Yesterday,
02:38 PM
cwhyu2
replied to a thread
Install of early warning siren
in
Electrical Forum discussion & Blog
Just before in the ground.
see more
13 replies | 984 view(s)
Yesterday,
02:19 PM
cwhyu2
replied to a thread
Install of early warning siren
in
Electrical Forum discussion & Blog
Point Isabel, siren removal and install.
see more
13 replies | 984 view(s)
Yesterday,
11:55 AM
Terry
replied to a thread
Unifit on home owner remodel
in
Toilet Forum discussions
In an old 1939 home I have not had an inspector make me change that dimension. Some old homes in Seattle are 7 feet for the bath. That meant 24"...
see more
2 replies | 47 view(s)
Yesterday,
11:13 AM
Terry
replied to a thread
Moen tub/ shower control, uneven pressure
in
Plumbing Forum Discussion & Blog
A thirty year old non-balanced Moen, the cartridge would not have much affect on water pressure side to side. If you have the pressure balanced...
see more
2 replies | 38 view(s)
Yesterday,
11:09 AM
Terry
replied to a thread
Kitchen sink backing up when washing machine drains
in
Plumbing Forum Discussion & Blog
The previous drawing you have posted shows many more fixtures. A standard laundry trap drain is pretty small. Some people are installing...
see more
9 replies | 28500 view(s)
Yesterday,
11:04 AM
Terry
replied to a thread
Is this ok... stand pipe, laundry tub, bar sink, shower plumbing
in
Plumbing Forum Discussion & Blog
When the fixture above drains quickly, like pulling the plug and draining, it can siphon the trap below. Will the bar sink drain slow enough?...
see more
6 replies | 100 view(s)
Yesterday,
10:52 AM
Terry
replied to a thread
Is this ok... stand pipe, laundry tub, bar sink, shower plumbing
in
Plumbing Forum Discussion & Blog
And they do reject it when inspected. But this guy is just up the road from me, and maybe in BC it's okay. I don't like doing things twice, so I...
see more
6 replies | 100 view(s)
Yesterday,
10:23 AM
Terry
replied to a thread
Help with changing Price Phister knob to Moen lever tub handle
in
Shower & bathtub Forum & Blog
I believe you have a Price Phister cartridge there. It's not a Moen cartridge in the wall. Price Phister Avante valve You need something...
see more
1 replies | 46 view(s)
Yesterday,
04:21 AM
cwhyu2
replied to a thread
Is this ok... stand pipe, laundry tub, bar sink, shower plumbing
in
Plumbing Forum Discussion & Blog
Laundry tub needs a vent.
see more
6 replies | 100 view(s)
05-17-2013,
05:56 PM
Terry
replied to a thread
Kitchen sink backing up when washing machine drains
in
Plumbing Forum Discussion & Blog
In the UPC code, they don't allow a laundry tray to wet vent over a washer. They only allow wet venting on bathroom fixtures. Which a laundry...
see more
9 replies | 28500 view(s)
05-17-2013,
02:46 PM
Terry
replied to a thread
Connection of Water Intake Pipes to Shower Valve
in
Shower & bathtub Forum & Blog
Whatever it takes. You can run the pipe in circles if needed. They're saying "In a perfect world." it would be nice to have them with that...
see more
4 replies | 77 view(s)
05-17-2013,
11:02 AM
Terry
replied to a thread
No cold water in shower
in
Shower & bathtub Forum & Blog
No cold? You may have a thermostatic valve there, and it may just be giving you a tight range. Sometimes you can remove the valve and reinstall...
see more
5 replies | 79 view(s)
05-17-2013,
10:50 AM
Terry
replied to a thread
What caulk to use to seal water pipe through basement wall
in
Plumbing Forum Discussion & Blog
I would be thinking 100% Silicone on that. Too bad it can't be sealed from the outside. Water pushing up against the foundation is hard to seal. ...
see more
3 replies | 81 view(s)
05-17-2013,
08:41 AM
Terry
replied to a thread
Why do plumbing jobs always leak
in
Plumbing Forum Discussion & Blog
I would think so. Having a leak after a repair? How would anyone stay in business? Any good service plumber will be dependable. When I was...
see more
4 replies | 113 view(s)
05-17-2013,
06:58 AM
MACPLUMB 777
replied to a thread
New electric water heater on concrete slab
in
Plumbing Forum Discussion & Blog
http://www.getfloodstop.com/Water_Heater_FloodStop_p/fs34npt.htm This is the best to prevent flooding, it turns off water at the same time...
see more
15 replies | 258 view(s)
05-16-2013,
06:22 PM
Terry
replied to a thread
depth of the rough-in valve
in
Plumbing Forum Discussion & Blog
It depends on the valve. Some of the Home Depot stuff years ago had a tollerence of 1/8" Something like Moen may have 3/4", and if they are...
see more
5 replies | 112 view(s)
05-16-2013,
05:34 PM
Terry
replied to a thread
Remodeled Kitchen Sink Plumbing
in
Plumbing Forum Discussion & Blog
You may want to open the wall and see what can be changed there. If there is any way to lower the drain, or if not, get a shallower sink. First...
see more
6 replies | 168 view(s)
05-16-2013,
05:28 PM
Terry
replied to a thread
New electric water heater on concrete slab
in
Plumbing Forum Discussion & Blog
Since the advent of check valved water meters we are doing more and more expansion tanks on our water heater installs. Some parts of Seattle have...
see more
15 replies | 258 view(s)
05-16-2013,
10:09 AM
Terry
replied to a thread
Kohler Rochelle K3385-EB Ballcock & Flushvalve Replacement and Repair
in
Toilet Forum discussions
Two more pictures 2 2
see more
29 replies | 20285 view(s)
05-15-2013,
09:02 PM
Terry
replied to a thread
What exactly is a *close coupled* toilet - Drake 2
in
Toilet Forum discussions
The tank is coupled closely by the bowl, rather than having the tank mounted on a wall, and a chrome bend connecting the two. All of the II...
see more
4 replies | 131 view(s)
05-15-2013,
04:26 PM
Terry
replied to a thread
The CST454CUFG Drake II 1G is up on the Toto Web Site
in
Toilet Forum discussions
Get a $30 or $75 Rebate on Toilets in Seattle. Customers can receive a $30 rebate when they purchase a new WaterSense-labeled high-efficiency...
see more
19 replies | 3461 view(s)
05-15-2013,
04:19 PM
Terry
replied to a thread
Anybody have a wall Hung Toilet and REGRET it ?
in
Toilet Forum discussions
TOTO works with the Gerberit in-wall system too. The TOTO bowls come with Sanagloss, so I would be inclined to go that route. Though it's going to...
see more
7 replies | 180 view(s)
05-15-2013,
04:18 PM
Terry
replied to a thread
Drake II 1G Close Coupled Toilet - SanaGloss
in
Toilet Forum discussions
Starting June 1st, 2013, Seattle Public Utilities will be offering a $75.00 rebate to homeowners for a Premium Efficiency Watersense toilet. That's...
see more
6 replies | 325 view(s)
05-15-2013,
03:53 PM
cwhyu2
replied to a thread
Install of early warning siren
in
Electrical Forum discussion & Blog
T-128 controls.
see more
13 replies | 984 view(s)
05-15-2013,
03:37 PM
cwhyu2
replied to a thread
Install of early warning siren
in
Electrical Forum discussion & Blog
One of the sirens from above being installed Tuesday.
see more
13 replies | 984 view(s)
05-15-2013,
03:32 PM
Terry
replied to a thread
Identifying Tub Shower cartridge, Source for the BNK7005
in
Shower & bathtub Forum & Blog
Source for the BNK7005 http://www.fdsupply.com/item/bk7005/ (2 Pack) Replacement B&K* Control Cartridge Fits Premier*, B&K*, ProFlow* Single...
see more
6 replies | 5944 view(s)
More Activity
No More Results
About kingsotall
Basic Information
About kingsotall
Biography:
Obsessed with plumbing
Location:
Flagstaff, AZ Sitting on an upside down 5 gallon bucket next to the GO 68HD
Interests:
Reading plumbing code and books by Massey
Occupation:
Hand copper part cleaned ready to go
Signature
I just post cuz I like to see my avatar.
Statistics
Total Posts
Total Posts
1,262
Posts Per Day
0.73
General Information
Last Activity
08-23-2009
12:19 PM
Join Date
08-17-2008
3
Friends
cwhyu2
Consultant
MACPLUMB 777
TROJAN WORLDWIDE SALES RP
Terry
Forum Admin, Expert Plumber
Showing Friends 1 to 3 of 3
Find latest posts
View Articles
View Blog Entries