cwhyu2
Consultant

Normally we would do it from an inside wall to access the connection to an outside hosebib.

It doesn't really matter whether the manifold is before or after the 3/4" upstairs pipes as long as it's size properly.

Next It looks like you would have to change out quite a bit. The parts for the Drake II 1G ST453U are quite different than for the ST454E...

If may have need two wax rings if the flange was too low. http://www.americanstandard-us.com/assets/documents/amstd/install/Install_2826.pdf ...

There was a lot of money in smuggling it from Mexico. I believe they still use it there.

I like the Rheem units too. You might also look into tankless if you have a good enough gas supply there.

It may be easiest to work out from the CPVC I would cut it back and start over. The threads where the shutoff threads down look to be fine...

I had the TOTO Aquia for a while, and then changed it for a TOTO Double Cyclone. The Aquia was pre Ostomy bag, and the double cyclone was during...

Bottom of flange on top of finished floor.

Just before in the ground.

Point Isabel, siren removal and install.

In an old 1939 home I have not had an inspector make me change that dimension. Some old homes in Seattle are 7 feet for the bath. That meant 24"...

A thirty year old non-balanced Moen, the cartridge would not have much affect on water pressure side to side. If you have the pressure balanced...

The previous drawing you have posted shows many more fixtures. A standard laundry trap drain is pretty small. Some people are installing...

When the fixture above drains quickly, like pulling the plug and draining, it can siphon the trap below. Will the bar sink drain slow enough?...

And they do reject it when inspected. But this guy is just up the road from me, and maybe in BC it's okay. I don't like doing things twice, so I...

I believe you have a Price Phister cartridge there. It's not a Moen cartridge in the wall. Price Phister Avante valve You need something...

It should have been in electronics in the first place. Where are the Ground Rods ???? Don't get Thread Lock.

Laundry tub needs a vent.

You may want to make sure your tank is not water logged. Does it have a bladder ? You can check the voltage and current, to see if it is a voltage...

Yes I think she bought that on Ebuy for $100,000 from Maddona. That must be the case because Maddona has not been wearing it lately.

Just get the calculator out and see what you need. There are a few Variables in the formula. There are online calculators that can do a best...

That does look good. Where are the Fuses ? Nice work.

In the UPC code, they don't allow a laundry tray to wet vent over a washer. They only allow wet venting on bathroom fixtures. Which a laundry...

Whatever it takes. You can run the pipe in circles if needed. They're saying "In a perfect world." it would be nice to have them with that...

No cold? You may have a thermostatic valve there, and it may just be giving you a tight range. Sometimes you can remove the valve and reinstall...

I would be thinking 100% Silicone on that. Too bad it can't be sealed from the outside. Water pushing up against the foundation is hard to seal. ...

I would think so. Having a leak after a repair? How would anyone stay in business? Any good service plumber will be dependable. When I was...

Good deal, That leaves more for me.:rolleyes:

http://www.getfloodstop.com/Water_Heater_FloodStop_p/fs34npt.htm This is the best to prevent flooding, it turns off water at the same time...