Any bowl needs to set flat to the floor without rocking. Shim as needed, though we tend to shim the back and try to pin the front of the bowl to the...
The plumber who quoted $91 for the hot water drain pan was already charging $700 for installation of the heater (which included a new shut-off valve...
That kind of a fitting is just like a hose on an outside hose bib...the thing that seals is the gasket, not the threads which are only there to allow...
I haven't installed any Posi-temp valves yet, but it appears they are 180 degree symetrical like Delta and many other brands. If so, the the body can...
It's a raised Cape, the front roof is steep, and the back has a low pitch (don't know how much really until I get there). There are no soffit vents,...
You would be looking at the Vespin II if you wanted to go with the 14" Unift adapter.
Same tank, but a different bowl that allows moving it back 2"....
My experience has been that installing them WITHOUT a loop is a more direct route and uses less material, therefore it gives as good, if not better,...
MACPLUMB 777
E-MAIL JERRYMAC@TROJANWORLDWIDE.COM
35 YEAR MASTER PLUMBER, HEATING, ELECTRIC, DRAINS, FIRE SPRINKLERS, WATER HEATER AND BOILERS SINCE JAN, 1989
281-706-1631 7 DYS A WEEK SALES AND TECH. SUPPORT
here's how i handle this...if a customer opts to buy any fixture or equipment through me, faucet, sink, toilet, water heater, etc., then I will handle any warranty issues and no charge for service if required on said item for 1 year. If they supply it themselves then I don't give them the same "service warranty". That is my gaurantee that I will stand behind "my products", always bought through plumbing wholesalers.
Originally Posted by mikeplummer
Home Page
Find latest posts
View Articles
View Blog Entries
