Instructions says - Position the plaster ground in the hole so that its printed face is flush with the finished wall
What if plaster guard face is not flushed to finished wall but extending like 1/4" from the finished wall?
what could happen? it will look ugly because escutcheon will not flush with finished wall?
or we have room like 1/4" ?
Also - do we need to install water hammer arrestor - Previously I had IPS pipe plumbing and did not have any problem now changing to pex
What if plaster guard face is not flushed to finished wall but extending like 1/4" from the finished wall?
what could happen? it will look ugly because escutcheon will not flush with finished wall?
or we have room like 1/4" ?
Also - do we need to install water hammer arrestor - Previously I had IPS pipe plumbing and did not have any problem now changing to pex
Last edited: